Received my Brembo take offs... - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

intensifi · 07-28-2013, 11:18 PM

I finally had time to unpack, inspect and clean them.

The person I bought them from painted them red. Unfortunately the piston and dust boot were not masked off before painting.

I cleaned them off pretty well using a kitchen sponge with Simple Green.

The pics show what I was able to remove so far.

I'm thinking I should follow the procedures in this thread to change out the dust boots and fully clean the piston tops before using the calipers.

http://www.camaro5.com/forums/showthread.php?t=305558

Any suggestions?

07-28-2013, 11:18 PM	#1
intensifi Drives: '12 2LT Convertible Join Date: Mar 2012 Location: Belmont, California Posts: 1,701	Received my Brembo take offs... I finally had time to unpack, inspect and clean them. The person I bought them from painted them red. Unfortunately the piston and dust boot were not masked off before painting. I cleaned them off pretty well using a kitchen sponge with Simple Green. The pics show what I was able to remove so far. I'm thinking I should follow the procedures in this thread to change out the dust boots and fully clean the piston tops before using the calipers. http://www.camaro5.com/forums/showthread.php?t=305558 Any suggestions? Attached Images __________________ Mods: GM Locking Gas Cap, RS License Plate Frame, SS Brembos, ZL1 FrontEnd, 14/15 Convertible Top Last edited by intensifi; 07-29-2013 at 03:07 PM.