Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Page 1 of 5

Show 40 post(s) from this thread on one page

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (https://www.camaro5.com/forums/index.php)

- Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons (https://www.camaro5.com/forums/forumdisplay.php?f=11)

- - New Camaro SS Dyno Pull 384.4 RWH (https://www.camaro5.com/forums/showthread.php?t=21259)

MrGazinya

05-04-2009 04:00 PM

New Camaro SS Dyno Pull 384.4 RWH

Quote:

Originally Posted by Redline Motorsports

Couldn't wait any longer............got 225 miles on the car (mostly to get the 87 octane fuel the dealer put in it out....).

Made two back to back pulls;

Coolant was 190, oil was 200

Here are the results!

http://img238.imageshack.us/img238/4...arobaselix.jpg
http://www.5thgen.org/forum/showthread.php?t=12930

AFR was about 11.5 to 11.7 across the board............nice for the turbos!

Going to play with the tune in the next couple days!

Howard

Kyle2k

05-04-2009 04:09 PM

auto or manual?

LosXC451

05-04-2009 04:15 PM

this car is gonna be fun :evil: :burnrubber:

D1BADZ

05-04-2009 04:22 PM

Quote:

Originally Posted by LosXC451 (Post 456784)

this car is gonna be fun :evil: :burnrubber:

yes yes, it is quite a joy :chevy:

MrGazinya

05-04-2009 04:22 PM

Quote:

Originally Posted by D1BADZ (Post 456806)

yes yes, it is quite a joy :chevy:

fieldgoal00

05-04-2009 04:23 PM

it's an ls3 based on the vin spreadsheet

Flynbyu

05-04-2009 04:28 PM

Wow.

Usually you'll loose 65-70 hp from the flywheel. You only lost 42 hp?

~Brian

fdjizm

05-04-2009 04:51 PM

What kind of correction was used on the dyno?
seems like before correction numbers.. which would mean 450 plus at the crank unless it's a factory freak.

Flynbyu

05-04-2009 05:10 PM

Quote:

Originally Posted by fdjizm (Post 456897)

What kind of correction was used on the dyno?
seems like before correction numbers.. which would mean 450 plus at the crank unless it's a factory freak.

Kind of what I was thinking.

~Brian

Craig

05-04-2009 05:25 PM

That's comparable to what the LS3 Corvettes are putting down, so I doubt it's a freak. Those are impressive numbers, let's cross our fingers that they will turn out to be the norm.

radz28

05-04-2009 05:26 PM

HHHHHEEEELLLLLLOOOOOO!!!!

Nice. That's about what 'Vettes are puttin' down, isn't it? It'd be nice to know the factor, but this sounds pretty good :D

dankss

05-04-2009 05:27 PM

the dyno this was done on is a dyno dynamics, a little higher reading than the mustang dyno that the 364whp was done on.

Flynbyu

05-04-2009 06:21 PM

The highest pull on an LS3 Corvette I've seen...392rwhp & 376 rwtrq, bone stock and I thought that was a little high. That's a great pull on the Camaro.....especially if the car is brand new with low miles.

~Brian

Crowley

05-04-2009 06:29 PM

Very nice .. that is around where it should be (maybe a bit on the high side).... any info on the correction used etc?

thanks,
Crowley

All times are GMT -5. The time now is 10:36 AM.

Page 1 of 5

Show 40 post(s) from this thread on one page