Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com

Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com (http://www.camaro5.com/forums/index.php)
-   V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) (http://www.camaro5.com/forums/forumdisplay.php?f=76)
-   -   Trouble pulling 6L80e!! (http://www.camaro5.com/forums/showthread.php?t=299129)

KodyJoe 06-01-2013 12:34 PM

Trouble pulling 6L80e!!
 
Soo 9 hours of me and my buddies trying to get the damn thing out and I'm lost. Got all 7 bolts out of the bell housing, got the stock torque converter unbolted, all the lines are off, all the wires and disconnected. Is there something ontop of the transmission that needs to be unbolted? The tranny at the bottom is pulled away far enough you can stick your hand up to the flex plate but at the top the gaps closer maybe an 1/4". Anyone pulled a 6l80e?

429 06-01-2013 01:34 PM

pull harder.

SC2150 06-01-2013 05:05 PM

It takes 1 tech an hour or less to drop out....your doing something wrong.

Shifter, bellhousing bolts, torque converter from flex plate, driveshaft, cooling lines, and cross member.

Motion427 06-01-2013 07:53 PM

I took my tranny out yesterday.
I think I counted 8 bolts and not 7.

Nitroman28 06-01-2013 08:06 PM

you're missing the very top bolt. Should be 8 bolts total. Lower the back of the trans down some and you will see it.

there's 9 bolt hole total in the bell housing but the top left bolt is not used.

Zoom in on the picture.
http://www.eficonnection.com/eficonn...ages/6L90E.jpg

Sent from my HTC One using Tapatalk 2

BigMatt 06-01-2013 11:03 PM

Yup there's a bolt at the very top of the bell housing.

Netraa 06-02-2013 12:58 PM

And just to state the obvious, If you have a 1/4 inch gap at the top of the transmission already, I would be very, very sure you have as little strain on the bolt as possible when you do try and remove it. And... replace it when it's time to bolt stuff back together.

BLACK10 06-05-2013 03:39 PM

Quote:

Originally Posted by SC2150 (Post 6616513)
It takes 1 tech an hour or less to drop out....your doing something wrong.

Shifter, bellhousing bolts, torque converter from flex plate, driveshaft, cooling lines, and cross member.

30-40:Dmins

SC2150 06-05-2013 04:38 PM

Quote:

Originally Posted by BLACK10 (Post 6633322)
30-40:Dmins

Well, were not ALL supermen!! :thumbsup:


All times are GMT -5. The time now is 03:24 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.