02-12-2011, 03:20 PM | #1 |
NOW CAMMED & SUPERCHARGED
Drives: 2010 Camaro 2SS/RS Black w/ IOM Join Date: Oct 2008
Location: Ar
Posts: 2,336
|
Need another place to get switched 12+ for Gauges
I bought an add a circuit but if I cant use it for f17 or f18 in driver side fuse box inside because it is only for 10 amp fuse and I cant figure out how to do it. If someone could let me know where else I can get power from?
__________________
Livernois Motorsports: Maggie 2300 7psi, Livernois 2C cam/L99 to LS3 Conversion, Ported TB, Rotofab w/adm race scoop, adm trans cooler,Kooks headers no cats, Kooks 3" exhaust. METCO breather. Precision 2400 Vigilante TC. Eibach Lowering Springs & Swaybars. BMR Trailing arms, BMR Rear Cradle Bushings, BMR Toe Rods, BMR Differential bushings. Vossen CV3 20's w/ 305 Mickey Thompson @25psi. Zl1 front bumper. OE Zl1 Hood and matte black insert. 556RWHP/500RWTQ L99
|
02-12-2011, 06:29 PM | #2 |
You could tap into the same one running your maggie coolant pump.
Pass-through just above the battery cable at the firewall. I'm running a boost guage, an AFR guage and a radar detector off F17. No problems. |
|
02-12-2011, 06:31 PM | #3 |
NOW CAMMED & SUPERCHARGED
Drives: 2010 Camaro 2SS/RS Black w/ IOM Join Date: Oct 2008
Location: Ar
Posts: 2,336
|
How did you connect it to f17 though?
__________________
Livernois Motorsports: Maggie 2300 7psi, Livernois 2C cam/L99 to LS3 Conversion, Ported TB, Rotofab w/adm race scoop, adm trans cooler,Kooks headers no cats, Kooks 3" exhaust. METCO breather. Precision 2400 Vigilante TC. Eibach Lowering Springs & Swaybars. BMR Trailing arms, BMR Rear Cradle Bushings, BMR Toe Rods, BMR Differential bushings. Vossen CV3 20's w/ 305 Mickey Thompson @25psi. Zl1 front bumper. OE Zl1 Hood and matte black insert. 556RWHP/500RWTQ L99
|
02-12-2011, 09:05 PM | #4 |
|
replace the f17 20 amp with a 10 amp.....figure out which side is the down stream side of the fuse.....tap in on that side of the fuse....
__________________
Sleep well America.....my MARINE has your back......
|
02-12-2011, 09:59 PM | #5 |
Dog Is My Copilot
Drives: 2011 2SS/RS LS3 Join Date: Jun 2009
Location: Pittsburgh, PA
Posts: 1,394
|
Here is a gauge install how-to by Autometer...this may give you some ideas:
http://www.facebook.com/album.php?ai...d=282128680586
__________________
|
02-13-2011, 12:18 AM | #6 |
|
__________________
Sleep well America.....my MARINE has your back......
|
02-13-2011, 07:02 AM | #7 |
Drives: 2010 SS Join Date: Nov 2009
Location: Waco, TX
Posts: 186
|
|
02-13-2011, 08:28 AM | #8 |
NOW CAMMED & SUPERCHARGED
Drives: 2010 Camaro 2SS/RS Black w/ IOM Join Date: Oct 2008
Location: Ar
Posts: 2,336
|
where you you get that fuse tap at?
__________________
Livernois Motorsports: Maggie 2300 7psi, Livernois 2C cam/L99 to LS3 Conversion, Ported TB, Rotofab w/adm race scoop, adm trans cooler,Kooks headers no cats, Kooks 3" exhaust. METCO breather. Precision 2400 Vigilante TC. Eibach Lowering Springs & Swaybars. BMR Trailing arms, BMR Rear Cradle Bushings, BMR Toe Rods, BMR Differential bushings. Vossen CV3 20's w/ 305 Mickey Thompson @25psi. Zl1 front bumper. OE Zl1 Hood and matte black insert. 556RWHP/500RWTQ L99
|
02-13-2011, 10:17 AM | #9 | |
|
Quote:
i would think any auto parts store would have them or some variant.....
__________________
Sleep well America.....my MARINE has your back......
|
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
July Motor Trend, Camaro 3rd place to Mustang & Challenger | OldJedi | 5th Gen Camaro SS LS LT General Discussions | 123 | 04-28-2010 06:13 PM |
Local tire place messed up my paint, need advice | philipdistefano | 5th Gen Camaro SS LS LT General Discussions | 35 | 04-21-2010 07:12 AM |
L99 all over the place! | 2SSARMY | Dragstrip and Launch Techniques Discussion | 24 | 04-20-2010 10:51 PM |
Wheres a good place in North NJ to get a Maggie installed | stealth camaro | USA - NY / NJ / PA | 13 | 04-15-2010 06:24 AM |
Looking for a place to go hunting | ZZcamaro | Off-topic Discussions | 11 | 10-07-2009 11:53 AM |