Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
  
Roto-Fab
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Search Forums
Reload this Page Search Results
Homepage Garage Wiki Register Community Calendar Today's Posts Search


Page 2 of 5 1 2 345
Showing results 31 to 60 of 122
Search took 0.01 seconds; generated 70 minute(s) ago. Search: Posts Made By: Louis @ LG Motorsports
Forum: USA - California 06-29-2012, 03:07 PM
Replies: 32
Views: 4,820
Posted By Louis @ LG Motorsports
What shop do you use to get your car modified?

Trying to see what shops are popular in Cali:headbang:

Louis
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-28-2012, 12:10 PM
Replies: 112
Views: 19,687
Posted By Louis @ LG Motorsports
GM didnt make much, that WASNT electronic...

GM didnt make much, that WASNT electronic throttle, in the last 10 years.... Cable driven throttle is either 411 ECU from 4th gen later camaros, and some vans, etc, but after 05, most everything was...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-27-2012, 01:12 PM
Replies: 58
Views: 9,195
Posted By Louis @ LG Motorsports
If you are running a mild lobe, and you have...

If you are running a mild lobe, and you have accounted for the 1.8 rocker, there isnt an issue.

If you already have a cam setup for a 1.7, and your PTV and spring coil bind are built towards a...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-27-2012, 01:05 PM
Replies: 112
Views: 19,687
Posted By Louis @ LG Motorsports
That cam likes compression, I typically build...

That cam likes compression, I typically build them to 64/65cc with that same gasket. Dont be afraid to mill them more!
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-26-2012, 07:24 PM
Replies: 27
Views: 10,971
Posted By Louis @ LG Motorsports
They may be talking about "surge" which is in...

They may be talking about "surge" which is in gear, rolling at low RPM. "Lope" is idling, in neutral, think "brapity brapity brapity".....

Both can be minimized, but not entirely eliminated.
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-26-2012, 06:11 PM
Replies: 27
Views: 10,971
Posted By Louis @ LG Motorsports
The tuner cannot take out as much lope as you...

The tuner cannot take out as much lope as you think, unless you are willing to run it in open loop, and richen it up at idle. Fuel will really calm it down, if you throw some at it. Idling at...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 03-26-2012, 02:32 PM
Replies: 12
Views: 3,315
Posted By Louis @ LG Motorsports
Dang. 300* engine oil temp.... Time for some...

Dang. 300* engine oil temp.... Time for some upgrades!:popcorn::confused0068:
Forum: Member Car Journals 02-07-2012, 06:42 PM
Replies: 75
Views: 8,128
Posted By Louis @ LG Motorsports
Doors weigh 49 lbs, no nothing, just the metal...

Doors weigh 49 lbs, no nothing, just the metal part.
Forum: Forced Induction - V8 01-20-2012, 07:11 PM
Replies: 14
Views: 2,084
Posted By Louis @ LG Motorsports
I would lower the compression if your goal is on...

I would lower the compression if your goal is on pump fuel.

I would also make sure you have a great meth kit.
Forum: Forced Induction - V8 01-20-2012, 05:30 PM
Replies: 22
Views: 5,834
Posted By Louis @ LG Motorsports
There you go bud! Good work!

There you go bud! Good work!
Forum: Forced Induction - V8 01-19-2012, 01:41 PM
Replies: 9
Views: 3,683
Posted By Louis @ LG Motorsports
The ZR1 G9 cam will make more power than the...

The ZR1 G9 cam will make more power than the G6xb.

You have what appears to be very much a clone of the LS9. Our cam was developed for that setup, and works very well.

Louis
Forum: Forced Induction - V8 01-19-2012, 01:38 PM
Replies: 21
Views: 5,754
Posted By Louis @ LG Motorsports
Blower friendly on whose account? Did you know...

Blower friendly on whose account? Did you know that the cam in the LS9 and the cam in the NA LS7 are almost identical?
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-18-2012, 06:18 PM
Replies: 22
Views: 4,031
Posted By Louis @ LG Motorsports
Ill walk you through the install! If you are...

Ill walk you through the install! If you are handy with tools, and dont mind getting dirty, its not bad at all!

Maybe I need to take a road trip :D
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-18-2012, 06:15 PM
Replies: 19
Views: 4,908
Posted By Louis @ LG Motorsports
Smoking can be very risky too.

Smoking can be very risky too.
Forum: Forced Induction - V8 01-18-2012, 05:03 PM
Replies: 8
Views: 2,790
Posted By Louis @ LG Motorsports
They are both CTS-V pump assemblies.

They are both CTS-V pump assemblies.
Forum: Forced Induction - V8 01-18-2012, 05:01 PM
Replies: 21
Views: 5,754
Posted By Louis @ LG Motorsports
Its odd. I would add some intake duration, and...

Its odd. I would add some intake duration, and tighten up the lobe spread. What lobes is it on, and any idea what lift is? Total duration @.050 doesn't tell much.

Louis
Forum: Forced Induction - V8 01-18-2012, 04:57 PM
Replies: 21
Views: 10,143
Posted By Louis @ LG Motorsports
I did miss a P.... Oh well. I made my point :D ...

I did miss a P.... Oh well. I made my point :D

The RHS block has been ordered for this car. We will pill up to 150 or 175 and add a little boost, if we can. Goal is 1000 on spray. Then we will put...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-15-2012, 07:27 PM
Replies: 18
Views: 11,647
Posted By Louis @ LG Motorsports
Its all in the tune, thats for sure. They...

Its all in the tune, thats for sure.

They are still weak, but you can increase longevity by being smart with it.

Usually, the first sign of failure is sloppy shifts, then a lack of shifting...
Forum: V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) 01-15-2012, 07:24 PM
Replies: 11
Views: 1,949
Posted By Louis @ LG Motorsports
connect the slave cylinder. Sometimes they can...

connect the slave cylinder. Sometimes they can "hydrolock" and you will never get them in because the slave will not compress. If not, loosen the bleeder.

Itll go in, and the clutch will totally...
Forum: 5th Gen Camaro SS LS LT General Discussions 01-15-2012, 07:18 PM
Replies: 23
Views: 7,248
Posted By Louis @ LG Motorsports
We just dealt with one of their adjusters, and...

We just dealt with one of their adjusters, and while I cannot comment on the service prior to the accident, I can comment on the service post problem. They were slow to respond, and slow to send a...
Forum: Forced Induction - V8 01-15-2012, 07:14 PM
Replies: 300
Views: 40,766
Posted By Louis @ LG Motorsports
lol

lol
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-15-2012, 07:12 PM
Replies: 32
Views: 5,587
Posted By Louis @ LG Motorsports
Id like to see dyno results! Usually,with piping...

Id like to see dyno results! Usually,with piping that long, it can hinder performance regardless of being ram air or not.

Either way, great fab work!
Forum: Forced Induction - V8 01-15-2012, 06:36 PM
Replies: 21
Views: 10,143
Posted By Louis @ LG Motorsports
Prior Planning Prevents Piss Poor Performance. ...

Prior Planning Prevents Piss Poor Performance.

The most important thing is to understand what you are working with.

Fast.
Cheap.
Reliable.

Pick three :)
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-15-2012, 06:29 PM
Replies: 18
Views: 2,477
Posted By Louis @ LG Motorsports
Hey Apex chase, give me a call at the shop....

Hey Apex chase, give me a call at the shop. 972-429-1963, Anthony and I have been trying to get a hold of you via phone for a few months now with no success.

Louis
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-15-2012, 06:28 PM
Replies: 18
Views: 2,477
Posted By Louis @ LG Motorsports
Tuning wise, we change a lot, because we can....

Tuning wise, we change a lot, because we can. Torque management, limiter, timing, total Air/fuel, check engine lights, etc.

If you choose not to tune, you would not harm a thing. Only downside is...
Forum: Forced Induction - V8 01-15-2012, 06:20 PM
Replies: 21
Views: 10,143
Posted By Louis @ LG Motorsports
Love it, its great. Stockish feel, stockish...

Love it, its great. Stockish feel, stockish friction zone, easily slipable, and no chatter. We do carry them :thumbsup:



The parts that fail, Identical.

700 rwhp DD is possible, with proper...
Forum: Forced Induction - V8 01-15-2012, 05:22 PM
Replies: 30
Views: 3,750
Posted By Louis @ LG Motorsports
Alky control with 100% pure M3 or M5 meth. ...

Alky control with 100% pure M3 or M5 meth.

If you have a positive displacement car, make sure you get the MAF tracking method of injection. This will prevent the need to remove fuel in the lower...
Forum: Forced Induction - V8 01-15-2012, 05:17 PM
Replies: 40
Views: 5,849
Posted By Louis @ LG Motorsports
Hey Bull, take a turkey baster and suck all of...

Hey Bull, take a turkey baster and suck all of the fluid out of the clutch/brake resivoir. Put fresh fluid in it. go drive.

Do it all over again after the drive.

It will help with keeping the...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-15-2012, 05:13 PM
Replies: 18
Views: 2,477
Posted By Louis @ LG Motorsports
Honestly, if its JUST headers, if you bought our...

Honestly, if its JUST headers, if you bought our system, you can send me the computer out of the car, and I can put a base tune in it. Is it a dyno tune? No. However, we start ALL of our header dyno...
Forum: Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons 01-15-2012, 05:11 PM
Replies: 22
Views: 4,031
Posted By Louis @ LG Motorsports
If you do choose to have a shop install them, you...

If you do choose to have a shop install them, you can expect 300-600 for an install, depending on what system.

We are very very good at installing headers, and charge 600$ for install AND dyno...
Showing results 31 to 60 of 122
Page 2 of 5 1 2 345

 
Forum Jump

All times are GMT -5. The time now is 01:49 PM.

Contact Us - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com - Privacy Statement - Terms of Service / DMCA Policy - Top

Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2025, vBulletin Solutions, Inc.