Quote:
Originally Posted by SoChrisB
Rad is not blocked. Even put in mishimoto rad. Have bled the system properly. Even done gravity vs vacuum and have Even let motor run for an hour w cap open too. Replaced gaskets and studs too. Monitored cooling on log too. It's fine throughout and then 10 seconds after a run it jumps open almost immediately.
|
The information here says it is fine throughout and 10 seconds after a run it jumps open almost immediately. What is jumping open?
Are you doing an engine runnning cooldown to normal temp or shutting it down because it is hot?
I notice a 20 to 30 degree rise on my temp after a run depending on the day and watch the temp on the return to get it back close to normal.
When burping hot, does fluid come out or just gas?