Quote:
Originally Posted by ULTRAZLS1
I installed mine tonight and had a little problem.
I could not get the lid to seat properly with the rubber seal still attached to it. It was far too tight where it needed to be seated with the rubber still intact. I tried it like 20 times. After I took the rubber off it fit just fine. Where this is located it doesnt look like a big deal to leave it off. Shouldnt let much more hot air in I hope.
Should I try and get this to work? I dont know what else to do. I tried putting it exactly where the instructions stated and everything. Finally just gave up.
Any input on this?
thanks for the help
|
CAI has an account on here. I know they will help in a heartbeat. PM them or give them a call. I would want that seal on there.