View Single Post
Old 11-11-2010, 06:29 PM   #11
Ivan @ Southwest Speed
 
Drives: '15 Z06, '01 NBM SS, '97 SS
Join Date: May 2009
Location: Rio Rancho, NM
Posts: 12,161
Quote:
Originally Posted by SlingShot View Post
WOW !!! You are the first person to get a light ... Check your O2 sensor connections on the cats ...
Over 100 sets sold and yes, you are the first sir. I need to send you a TShirt.

Quote:
Originally Posted by 2SSCAMARO View Post
I would just clear the code for now and disconnect the battery cable for a few minutes to reset the trims. It may never return. If it does, then you may have to deal with it.
Quote:
Originally Posted by hypurone View Post
and for leaks at the manifold and downpipes connections as they will draw in air causing a false lean condition...
Quote:
Originally Posted by Slowhawk View Post
Make sure the driver side front 02 is plugged in. After that it might need an 02 sensor. I've had 2 cars in the shop with the same code.Both had other shops do the install and come to find out the 02's were stripped(common factory problem) and the shops used a torch to get them out.They fried them.

So,reset. If the codes come back quickly change the 02 or go to a shop to diagnos it properly. A lean code means it's dumping 25% more fuel on that side of the motor.
Quote:
Originally Posted by topgun1 View Post
no codes thrown or SEL on mine either with the DT shorties, even with the hiflow cats installed. yep, like slohawk said, you're getting more fuel on that side of the motor.
Looks like you have alot of the same responses. I'd think that there is a leak upstream without a doubt.

Quote:
Originally Posted by moodysilver10 View Post
Problem fixed?
Ditto....call me or let me know if you need any support at all.

Ivan @ Southwest Speed
Ivan @ Southwest Speed is offline   Reply With Quote