|
[LS3]
Lifters (7000RPM) - Pump Up Issue
Timing Chain Tensioner (550HP) - Fails
Oiling (6500RPM) - Can't keep up
Rods (600HP) - Break
Head Gasket (600HP) - Fail
Pistons (600-625HP) - Fail (Detonation / excessive boost)
Crank (900HP) - Good until this point
Exhaust Valves(10PSI) -Fail
Fuel System (450HP) - Can't keep up
[L99]
AFM (450HP, High Lift / RPM) - Delete and convert to conventional
Valves (high lift) - Float, Replace
[Both]
Rockers(high lift) - Fail (Bearings Explode)
Balancer (Cam/RPM) - Explodes
[TR6060]
Main Shaft(Stock+HP) - Output Shaft Failure (This is known of..Recalled too)
Rear Support Bearing(650-680hp) - Fails
Synchro Rings (525-625) - Failure
Clutch (600) - Fails
[4L80]
TCM(Any Mods) - Recalibrate
Torque Management - Recalibrate PROPERLY
Torque Converter (500hp) - Can fail
[IRS / Driveshaft]
Suspension Flex(450hp) - Toe Arm Failure
Rear Subframe(475hp) - Flex, Use Subframe Bushings
Gears (500hp) - Fail
Halfshafts (500hp/Wheelhop) - Fail
Posi (Various) - Can Slip / Fail
Driveshaft (Over 5,000 DRIVESHAFT RPM) - Fail
I might just scan and post..depending how mad the moderators may get
|