[2010 SS RS]

I did not want to sound like a kool aid drinking fanboy so I stopped at dealer and played with the facia. You can grab it right over the bowtie and lift the car up to the point of flexing the shocks with absolutly no give or flex. As you move along the lip there is no flex or movement. That would dispell the BS that this is high speed caused because I applied way more lift than wind lift on a surface would have caused. So then I applied downward pressure and it was actually much stronger and more solid feeling in that direction. Makes sense since air pressure would actually be pushing the front end down. When looking at the dynamics of the facia and the damage shown in the picture I would suggest that this was caused by severe collision with something down low. Perhaps smashing the nose into a curb or on the far up side of a dip. This would transmit torque up to where the damage is shown and cause a pulling action at that point. The front is pretty low and I would think that caution should be taken going thru dips or parking to avoid damage. Not unusual for a car like this. The Vette has about the same front clearance and many Vette owners report the caution they use to approach curbs and dips. To keep lift from under a car at top speeds the front must be low. I would suggest along with Milk....Read the entire thread.....check a car out yourself....and dont panic over an issue that was reported second hand. 9Ball saw the damage but he was not there when it occured....He jumped to conclusions as to its cause and there is absolutly no high speed air pressure evidence that caused the cracks......Use some common sense please.