Quote:
Originally Posted by cdb95z28
You know those air in a can dusters used for electronics? When you turn them upside down the air comes out super chilled. Aim that super cold air right at the bolt, longer the better. The super cold will shrink the bolt and sometimes they will break free. I have done this before and it works. Just do not aim the air at your skin, because you will get frostbite.
|
That's a great idea. I've seen that method used for a multitude of close tolerance part assembly. You can install wheel bearings without a press the same way. Just heat up the hub a little and pop the bearing in the freezer for a while and they go together with almost no effort.