You are browsing camaro5 
 |
|
03-22-2011, 06:53 PM
|
#1 |
 Drives: Chevrolet Camaro 1LT 2010 V6 A6 Join Date: Aug 2010
Location: Finland, Kerava
Posts: 172
|
Removing back bumper?
Going to install aftermarket back up sensors.
So I need to remove back bumper. Any tips of DIYs? |
|
|
|
03-22-2011, 07:26 PM
|
#2 |
Drives: 2010 Camaro 2LT VR/RS CGM Rally's Join Date: May 2009
Location: Palmyra, PA
Posts: 5,675
|
just remove the 3 torque screws in the wheel well then the bolt on the inside near the sidemarkers pull out soo the unclip then go under the car and their are big tabs push in the taps if you need a pic PM me and pulll out make sure to disconnect the tail lights!
__________________
|
|
|
|
|
03-22-2011, 08:34 PM
|
#3 |
 
|
"Search" it. I removed mine a couple weeks ago to put on my quad exhaust. There is a thread on here that shows the GM instructions for removing rear fascia. Easy, but scary if youve never done it before. PM me if you need some help.
__________________
 |
|
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: LS3 Camshaft Install (a lot of pictures, may take a moment to load) | robertway | Camaro DIY & HOW-TO instructions & discussions | 313 | 12-16-2023 07:53 PM |
| betcha ain't nobody doing this... | zebra | Member Car Journals | 58 | 06-18-2018 09:51 PM |
| Rear Bumper Alignment | PB3 | Cosmetics and Lighting Modification Discussions | 15 | 03-03-2011 03:03 PM |
| orange10s.c. AKA Gary's Customz has not fully delivered on product | sykb47l | Vendor and Seller review / feedback / experiences | 149 | 12-15-2010 01:47 AM |
| The perfect background song for the first Camaro TV commercial...Get Back! | Rob53 | 5th Gen Camaro SS LS LT General Discussions | 44 | 01-12-2009 06:53 PM |
