![]() |
|
|
#1 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
WHY?? PO223 TB code, won't run without reduced power.
I took off the TB, played with it for a bit, took off the clamps that hold the plastic part on. Put it all back together, and now she won't run without that code and the reduced power. I've cleared it a thousand times. HELP PLEASE!
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#2 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
The code is for TB high voltage. I don't know what's happening.
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#3 |
|
crazier than a coconut
Drives: 2010 2SS/RS LS3 Join Date: Jul 2010
Location: virginia
Posts: 1,547
|
what plastic clamps are you talking about? did you take the connector apart?
__________________
|
|
|
|
|
|
#4 |
![]() Drives: 2011 Cyber Gray Camaro Join Date: Mar 2012
Location: Salt Lake City, UT
Posts: 152
|
I got that code yesterday while i was installing my black ice isolator and it was because i had forgotten to reinstall one of the sensors on the passenger side kind of below the TB. I'm sure you've already checked all the connections, but i just thought i'd throw in my two cents just incase.
__________________
BBk LT Headers/ Injen LT CAI/ MRT v2/ RX Catch Can/ Black Ice Insulator/ Trifecta Tune/
![]() ![]() ![]() ![]() |
|
|
|
|
|
#5 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
well, metal clamps, holding the plastic part of the TB on.
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#6 | |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
Quote:
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
|
#7 |
![]() Drives: 2011 Cyber Gray Camaro Join Date: Mar 2012
Location: Salt Lake City, UT
Posts: 152
|
this might help. so i got that code, (the car shook and died on me because i had forgotten to connect that sensor) reconnected the sensor, and it still had the code. then i disconnected the negative port on the battery, (15 seconds), reconnected it, then started the car. It ran perfect but the code stayed on for about one mile of driving, then it went away and couldn't be better
__________________
BBk LT Headers/ Injen LT CAI/ MRT v2/ RX Catch Can/ Black Ice Insulator/ Trifecta Tune/
![]() ![]() ![]() ![]() |
|
|
|
|
|
#8 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
Another thing, The service stabilitrac comes on as well.
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#9 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
I tried driving it, but it's undriveable.
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#10 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
pearl, did you get the engine reduced power?
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#11 |
![]() Drives: 2011 Cyber Gray Camaro Join Date: Mar 2012
Location: Salt Lake City, UT
Posts: 152
|
I got both of those. on the screen is said engine reduced power and the engine kept bogging and after about 10 seconds died. then i realized that i hadn't connected that sensor. Once that was plugged in the car ran fine, but it still said service stabilitrac and had a picture of a wrench i believe. Plus all the little lights were on like traction control and all that. So again, once that sensor was plugged in the car ran fine but i still had the lights and the service stabilitrac. At that point i disconnected the battery hoping it would clear them but it didn't. (i wasn't too worried because i knew other people had said that they got those lights after doing the install but they went off after a minute of driving) so sure enough, about 30 seconds after i left my house they all went off and it was as good as new.
__________________
BBk LT Headers/ Injen LT CAI/ MRT v2/ RX Catch Can/ Black Ice Insulator/ Trifecta Tune/
![]() ![]() ![]() ![]() |
|
|
|
|
|
#12 |
|
Engineer in Training
Drives: IBM 2010 Camaro LS Join Date: Nov 2011
Location: Alabama
Posts: 292
|
Mine are plugged in, but it still won't run. I'm reflashing the car, I hope this fixes it
__________________
K&N Aircharger CAI, BBK LT's, VMAX black ICE, Trifecta tuned
|
|
|
|
|
|
#13 |
![]() Drives: 2011 Cyber Gray Camaro Join Date: Mar 2012
Location: Salt Lake City, UT
Posts: 152
|
so it was only the throttle body you removed? and didn't mess with anything else?
__________________
BBk LT Headers/ Injen LT CAI/ MRT v2/ RX Catch Can/ Black Ice Insulator/ Trifecta Tune/
![]() ![]() ![]() ![]() |
|
|
|
|
|
#14 |
![]() Drives: 2011 Cyber Gray Camaro Join Date: Mar 2012
Location: Salt Lake City, UT
Posts: 152
|
and when you say undriveable, could you elaborate a little? will it start then die? not start at all? run but run really boggy?
__________________
BBk LT Headers/ Injen LT CAI/ MRT v2/ RX Catch Can/ Black Ice Insulator/ Trifecta Tune/
![]() ![]() ![]() ![]() |
|
|
|
|
|
|
|
![]() |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anybody Spray'n their SS yet - nitrous ? | WeeZee | Forced Induction - V8 | 37 | 12-29-2012 10:56 PM |
| STAINLESS POWER: Affordable Performance and Sound | Starting at $599 SHIPPED @ Apex! | Apex Motorsports | V8 Bolt-Ons & Tunes | 18 | 08-09-2012 06:20 PM |
| Nitrous System ?????s | PoleCat2SSRS2010 | Forced Induction - V8 | 29 | 12-08-2010 06:55 PM |
| Camaro Running on Reduced Power?!?! | dplyttle | 5th Gen Camaro SS LS LT General Discussions | 10 | 08-18-2010 12:37 AM |
| Motorgen LA Invasion Videos (58) and Pics Thread | SeanPlunk | USA - California | 5 | 05-31-2009 02:23 AM |