You are browsing camaro5 
 |
|
11-11-2017, 10:31 AM
|
#1 |
 Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Which way does MAF face???
Doing a swap and putting a 2015 LFX into my Scion FRS. That said,, just got the MAF sensor and not sure which way it faces. I would assume the opening faces into the air stream but not sure.
Can someone confirm?? |
|
|
|
11-11-2017, 08:28 PM
|
#2 | |
       
|
Quote:
__________________
 Mods, K&N CAI ,VTC , GM Perf Axleback Exhaust, Elite Eng CC and CSS, GM Strut Tower Brace,Carbon Fiber Anvil Spoiler,ASC T5 Splitter,Gen5diy Foglight kit. |
|
|
|
|
|
11-12-2017, 08:44 AM
|
#3 |
|
Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Thanks!!!!!!
|
|
|
|
|
11-14-2017, 03:29 PM
|
#4 |
Drives: 2012 45th Anniversary Edition Join Date: Aug 2012
Location: San Diego, CA
Posts: 1,618
|
Plus, i think the holes are oriented in the tube for it to fit only one way
|
|
|
|
|
12-20-2017, 01:18 PM
|
#5 |
Drives: 2012 Camaro RS 2LT 6spd man Join Date: Aug 2013
Location: Dickinson, Texas
Posts: 536
|
I think there is an arrow on the part orienting the way it's supposed to be installed.
|
|
|
|
|
12-20-2017, 01:24 PM
|
#6 |
|
Instagram: Sangstah
|
whoa sounds like a unique build, any photos?
|
|
|
|
|
12-21-2017, 10:35 AM
|
#7 |
|
Drives: 2016 C7 Join Date: Apr 2017
Location: Key Largo
Posts: 52
|
Build thread is here.
http://www.ft86club.com/forums/showthread.php?t=117334 Should scoot pretty good when done,, FRS is 2750 Lbs so quite a bit lighter than a Camaro. Biggest issue has been with the FRS's rear cross member. Had to get an Oil pan from a Holden out of AU. Also had to recess the clutch master 2 3/4" into the firewall to clear the HP pump on the motor. Motor mounts are done,,, starting transmission mounts and exhaust systems now. |
|
|
|
|
|
|
|
 |
|
|
