You are browsing camaro5 
 |
|
10-14-2019, 06:28 PM
|
#1 |
 
Drives: 2011 2SS Inferno Orange Join Date: Oct 2013
Location: Cedar Hill, MO
Posts: 60
|
LSA isolator coupling
Well as luck would have it in going to be replacing the isolater in my supercharger.
I'm pretty sure I know the answer to this question but what the hell I'll ask. Can I get the snout of without removing the blower? I tried, but the search will not work on my phone apparently none of my stuff works right... Lol
__________________
2011 Camaro SS
Buckets of money under hood! |
|
|
|
10-14-2019, 06:45 PM
|
#2 |
     
|
It's worth a try, but on my 2014 ZL1, I could not get the snout off without removing the blower. Since I had to take the lid off to remove the SC, I had a company reinforce my intercooler since I was in there so I can run more boost in the future. The lid rear bolts were a PITA and required several 1/4" drive extension of varying length, a universal joint, and of course sockets. Once you know the bolts are loose from their threads, you can let the grommet in the lid hold the bolts in place while you lift off the lid. Trying to fully remove the bolts will probably result in dropping it behind the engine into no mans land. Since you have the 2.5" upper already, are you sure it hasn't been done already??
Good Luck |
|
|
|
|
10-14-2019, 07:16 PM
|
#3 |
|
Drives: 2011 2SS Inferno Orange Join Date: Oct 2013
Location: Cedar Hill, MO
Posts: 60
|
I bought charger used 2 years ago, if it's been done I do not know? I'll find out soon.
I just remember the PCV vent is sticking up from the galley cover. I think that's gonna hose me.
__________________
2011 Camaro SS
Buckets of money under hood! |
|
|
|
|
|
|
|
 |
|
|
