![]() |
![]() |
#1 |
![]() Drives: 2010ss M6 LS3 Join Date: Jun 2018
Location: Alberta Canafa
Posts: 38
|
My road track wheel setup, what you think?
Hey guys, just looking for bit feedback on a dedicated road track use wheels for my 2010ss, car has 1.5” lower springs/sway/fully poly bushings everywhere/toe arms/trail arms/caster plates/No coil overs....
I kinda want to stick to 20”. I found a set of stock 5 spoke SS rims that are all square rears at 9.5” x4 (think factory rear offset is 40mm) . Was thinking of installing 285/35/20 square on these factory 9.5” rims. I did see that 285/35/20 did recommences 10” wide rim but only .5” less probably fine? These rims are priced right. Opinions? Posted in tires section but not much info, Thanks guys, great site!! |
![]() |
![]() |
![]() |
#2 |
![]() Drives: 2010ss M6 LS3 Join Date: Jun 2018
Location: Alberta Canafa
Posts: 38
|
Shoot wheels sold....., but I'm thinking of same plan with possibly aftermarket rims: 20" stock offset 40mm and 10-11" wide and mounting track tires (100 treadware) 285/35/20.
My main concern is rubbing/fitting? input?? |
![]() |
![]() |
![]() |
#3 |
![]() Drives: 2010ss M6 LS3 Join Date: Jun 2018
Location: Alberta Canafa
Posts: 38
|
Being looking like crazy for another set of wider square rims 10-11" wide and no luck.
So maybe go different route and install all 275/40/20 on my factory staggered 20" rims? Track tires. I see the front rims only 8.5" wide and 275/40/20 recommend 9" but i addume only 0.5" isnt a big deal. |
![]() |
![]() |
![]() |
#4 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 2SS/RS Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 6,076
|
Are you looking at Camaro6 as well??
__________________
Orange Krush II
1LE Front sway bar, Splitter, shocks and struts, Z28 dual mode mufflers, Intake, UCA Bushings, and Toresen 3.91 Diff. 1 piece DSS Drive Shaft, ZL1/C7 Calipers, and 32mm JPSS Rear Bar. ASC race spec splitter and wicker. 6th Gen M017 Wheels. Stainless Works 1 7/8 LTs. DSE and PAFDT Suspension components. |
![]() |
![]() |
![]() |
#5 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 2SS/RS Join Date: Dec 2009
Location: Clarksville Tennesse.
Posts: 6,076
|
__________________
Orange Krush II
1LE Front sway bar, Splitter, shocks and struts, Z28 dual mode mufflers, Intake, UCA Bushings, and Toresen 3.91 Diff. 1 piece DSS Drive Shaft, ZL1/C7 Calipers, and 32mm JPSS Rear Bar. ASC race spec splitter and wicker. 6th Gen M017 Wheels. Stainless Works 1 7/8 LTs. DSE and PAFDT Suspension components. |
![]() |
![]() |
|
|
![]() |
|
|