![]() |
|
|
#1 |
![]() Drives: 2016 Lt 1985 Irocz28 Join Date: Mar 2018
Location: AZ
Posts: 3
|
Hi guys not sure if I'm in the right section if not can someone move me pls. So here I go I have a 2016 v6 with about 112k miles I installed aftermarket hids years ago and have replaced them a couple times different brands too last set installed about 3 yrs ago I noticed my driver light was out so I swapped bulbs to check if it was the bulb or the balaster looks like the balaster since there's 12v at pig tail but no working light after ordering a new set I noticed my passenger side driving light wasn't working I was like wtf I'll check it on my days off then yesterday while getting home I put the left turn signal and after flashing normal for a few seconds it went into a fast flash so naturally I assumed one of the bulbs went out today after work I check the blinkers and it was the rear one I went to swap it with a new one and after install still nothing so I had my friend step on the brakes and nothing only the middle one and the right one so I had him turn on the lights and to my surprise my passenger parking lights front and back don't work my front driver parking light doesn't work and still my brake/left turn signal doesn't work any ideas greatly appreciated multi switch seems to work as if I turn only parking lights or all lights it shows on dash same as if I turn on or off the automatic light control same for left, right blinkers and hazards everything on dash shows working but not outside thanks again
|
|
|
|
|
|
#2 |
![]() Drives: 2016 Lt 1985 Irocz28 Join Date: Mar 2018
Location: AZ
Posts: 3
|
Problem solved! If anyone has the same issues it was the fuse for BCM4 in my case on the engine bay fuse box
|
|
|
|
|
|
|
|
![]() |
| Tags |
| lighting issue |
|
|