MBRP Exhaust

[Bad Dad]

If i use the MBRP catback will i be able to bolt up to long tube headers and high flow cats later such as ARH or Kooks ??

[SummoneR]

I have it on my LS3... LOVE IT!!!
Sorry no help for the L99.

[SummoneR]

Originally Posted by Bad Dad

If i use the MBRP catback will i be able to bolt up to long tube headers and high flow cats later such as ARH or Kooks ??

Depends. I plan to have a custom piece made to attach to my MBRP cat back and long tube headers. the MBRP I have has a reducer from the 3" to the stock diameter. So if you get headers that allow you to connect to the stock exhaust location then you can do this. I wonder if MBRP would offer a non reduced pipe section to match the stainless steel used so those of us who want to use headers can just plug them right in. I know stainless works offers headers that tie in at the stock exhaust location.

There was a thread here too that shows using a MBRP exhaust with the front and mid x pipes of ARH and their headers to achieve this too.
http://www.camaro5.com/forums/showthread.php?t=36329

[MBRP Tech]

Originally Posted by miltp

MBRP TECH,My camaro is a 2SS auto ,but i am tuning out the AFM or DOD.Should i then purchase the Cat Back System for the 6 speed manual(I also have the Ground effects) .I am getting ready to purchase this system and want to be sure.Oh and the drone i was refering to was when your in the car crusing is there much sound on the inside. Thanks

If you are disabling the DOD for sure, then yes you can use the 6 speed system if you want...but if you are not 100% on the DOD shut off yet, go with the auto set up. The auto set up is a little quieter on the outside with the resonator x pipe set up vs the the 6 speed system...but very close.

As for the inside, you can cruise along and have a normal conversation without the exhaust being bothersome for sure...get on the throttle and you definately know that there is a aftermarket system on the car...nice deep note without being over the top.

[MBRP Tech]

Originally Posted by ************

If you don't mind be trying to answer your questions. If you have the LS3 6spd you should go with this kit form MBRP http://www.************.com/mb304stcatba.html

I am almost postive that the gains made with this exhaust is from just the cat back exhaust and no other mods were done but I could be wrong. If you added a set of long tube headers then wrhp gains would be even more.

************ is absolutely correct, we test on completely stock vehicles.

[SummoneR]

Originally Posted by MBRP Tech

************ is absolutely correct, we test on completely stock vehicles.

I wish you guys made headers too. I'd love to have a complete MBRP exhaust system.

[HeavyD]

Me too!