Cheapest mods you have made to your camaro <$100

[Ratt]

Originally Posted by hightower

I'm interested to see it installed. As the above said, it looks heavy, lol

Its made out of aluminum and only weighs 4 pounds. It mounts where an ADM race scoop would.



The opening is larger than an ADM scoop and funnels more air. It has a lid so all the air goes into the cold air intake box.

[A7x6]

where can i get my bowties blacked off? is there a shop where they do it at?

[hightower]

Originally Posted by A7x6

where can i get my bowties blacked off? is there a shop where they do it at?

You can get vinyl to cover the bowties. They make pre-cut pieces and sheets that you can cut out the bowtie and put it on. I would recommend buying a vinyl sheet rather than pre-cut bowties. Then you can lay an entire sheet over your bowtie and cut around the edges. It will fit perfectly if not better than the pre-cut pieces. If you need more help, let me know via PM.

[Saint Alban]

Got 12" LED strips from eBay (seller: future_LED) and put them under my doors as a courtesy light. They light up a very large area. A pair is only about $15. I put white for visibility, red for show. Connected to dome light wire.

[djxrated81]

for under 100 bucks i got blacked out side markers, deceptcon bowtie black outs they threw in the bowtie black out for my center caps of my rims. also stealth auto clear turn signal blubs. (takes the egg yolk look away)

[OHIOSS]

This was a mod that was under $100:

[djxrated81]

O and i forgot i also got the slp low temp thermostat for 30 bucks

[BLACKWIDOW.SS]

Just ordered SS fender badges $36, red LED interior bulbs $7, marker light black out kit $24, "6.2 SS" hood decal $20, Camaro SS plate frame $40.

Soon to come: (some not under $100) Inferno gas/brake pedals, red caliper covers, Camaro SS dash decal $17, chrome gills, Black lug nuts $40, center cap decal $20, Bowtie valve stem caps $20, lowering springs, colored headlight halos, SS floor mats, black rims, chrome engine dress up kit (several pieces separately under $100).

[1CamaroSS]

Engine cover decal sets "Chevrolet and V 8" $20

[Camaroshark]

Originally Posted by 1CamaroSS

Engine cover decal sets "Chevrolet and V 8" $20

Where did you get those done? Mine has a custom paint but I think decals would set it off nicely.

[RJTV6A]

Clear license plate cover$6.00, Spray bomb from the dealership $12.00

[plowxman]

Originally Posted by PoorMansCamaro

Probably already mentioned, but if not:

Stock turn signal bulb


Chrome turn signal bulb


Cost was $23 and some change. Free shipping special when I bought them. Took less than 15min to install myself.

i tired to take the one out by the intake and its almost impossible, howd u get aaround that??

[JPDeMircift]

You actually can't get around the intake (at least I wasn't able to). In order to get to the signal bulb you must open up the intake by the tabs that are on the sides of it, take out the filter, and push the that plastic piece of the intake in or out (I forgot which way it goes) and that is how to get to the bulb. Then put it back it back together when you are done. Oh and that plastic piece of the intake does have like a crack looking line going through the top of it so don't think you cracked it when popping it in and out

[2011*Camaro*SS]

for exactly $100 I blacked out all my lights (Headlights, DTR Lights, Side Markers, Ext.) and both my bow ties and the little bow ties in the wheels