rim sizes??

[SD2011SS]

Anyone have a 20x12 set up on the rears without a wide body?? Pics if you have them would be great and any advice is appreciated..

[FEN]

20x11.5 is the widest your gonna run and still be inside the wheel wells....and the offsets need to be good. My 11.5" w/305/35 sit 1/4" inside the wells and with 315/35's you will be flush on the outside and have aprox 1/4" clearance between the tire and the inner wheel well liner.

[SD2011SS]

That looks really good I kind of want them to bulge out just a litttttle bit which is why I was thinking 20x12 and 20x10 on front... will it affect turning radius by much?

[FEN]

My car turns fine with no rubbing. My front tires are very close to the strut and sit 1/8" inside the wheel well. I would just run an 11.5" out back with a 315/35 and make sure the offsets are correct.

[Bad70supreme]

Originally Posted by SD2011SS

That looks really good I kind of want them to bulge out just a litttttle bit which is why I was thinking 20x12 and 20x10 on front... will it affect turning radius by much?

I like your thinking, I believe the car would look pretty sick with just a hair of tire outside the body with a very wide tire.

[BiG_TiMe]

Originally Posted by Bad70supreme

I like your thinking, I believe the car would look pretty sick with just a hair of tire outside the body with a very wide tire.

yea same here, i like it when u can see the tire sticking out from the body

[SD2011SS]

Originally Posted by BiG_TiMe

yea same here, i like it when u can see the tire sticking out from the body

I know right? The ZL1 sits on 20x10 285/35 on front and 20x11 305/35 on rear and it looks just amazing! My only problem is I want to order forge star cf5's and they don't have any in the deep concave until the end of the month.. its really putting a damper on my dyno tuning plans until I can get new rims and tires..