What Did You Do To Your Camaro Today?

[Bcarr]

Originally Posted by RedDevil11

Plastidip on all my emblems and lights

You might want to "unplastidip" those lights if you actually plan on driving that car on the road!

[RedDevil11]

Originally Posted by Bcarr

You might want to "unplastidip" those lights if you actually plan on driving that car on the road!

Yeah I was going to, just doing a little experimenting. Just going to tint them

[Bcarr]

Originally Posted by 45TH RS

Bcarr ... your 45th looks great! Like that garage floor too!

Thanks. Racedeck is awesome!

[GunnyG]

Charged my battery, because the sucker keeps on dying on me!

[Asphalt]

Ordered my first round of Mods from Apex Chase and finally hit the speed limiter

[RED HT5]

Drove mine and made sum heads turn...

[Normagene]

Recently installed my Technostalgia Sequential Taillights, but the wire for the "show mode" I need to run to the drivers seat and install a switch. Never ran any wiring so I'm not sure the best way from the trunk to drivers seat. What trim to run under etc. Couldn't find a DIY any wiring from the back to front. Like to take the path of least resistance. If you have done this I could use some guidance. Thanks. Lights work great by the way.

[Mvp_Me]

Originally Posted by RedDevil11

Yeah I was going to, just doing a little experimenting. Just going to tint them

i was just thinking to myself and said "it'll probably last two days at max before you get pulled over"

[Freyguy08]

Originally Posted by SERVED_USMC

Do you have a link for these?

Looks awesome!

Thanks man! Here ya go.

http://www.rpidesigns.com/shop/item.aspx?itemid=1874

[whemming]

Hotchkis Springs installed and a ZL1 Spoiler

[SeriouslySinning]

Took a rock to the roof when driving back from NY... only about 40 miles to go when I heard a loud thud. Chip to paint and primer.

Thats the third chip in my paint so far. two on front bumper and one on roof. Hoping to get one in each panel just for good measure........................................

[SeriouslySinning]

Originally Posted by RedDevil11

Plastidip on all my emblems and lights

how do you get the plastidip out from inside the letters?

[RedDevil11]

Originally Posted by SeriouslySinning

how do you get the plastidip out from inside the letters?

I used a tooth pick it works well

[RayTheRat]

Installed a set of Sullivan Products pedals...while I was installing 'em, I noted that the masking take used to mark the holes for mounting showed thru the pedals...and I was using blue tape. That gave me the idea of using red tape which matches the color scheme of the rest of the car. I think it turned out ok. I also used some touch-up paint to add a bit of red in the centers of the attaching screws.

I also replaced the incandescent driving lights with LEDs. Much better; white light instead of yellowish.

A large part of the weekend was spent at 2 car shows (one with a pinup contest...my car made a nice background for a couple of the models). After the shows, I decided to go apeshit and ordered $1200 worth of parts, including "light show halo" lights and a buncha underhood stuff.

Then I've been editing photos to put on my server. Here's a link to one of the shows' photos:
http://www.chevyasylum.com/cruisin/c...4/Welcome.html

Now it's time to start on the red ABL kit.