V8 bolt on help desk! Now available!!

[Nightmare2012]

Originally Posted by litle88

Thanks Oz!

Anytime ls3ss and muddflap might want to take a look st these if they really plan on maximizing their build.

[Muddflap]

Originally Posted by Nightmare2012

Anytime ls3ss and muddflap might want to take a look st these if they really plan on maximizing their build.

I'll take a look. I was just looking at some Mast heads. They are around $1,300-$1,800 each

[MikeMoach]

litle88 if you could check that PM I sent you a day or two ago I would really appreciate it

[litle88]

I replied sorry but I didn't get a notification of your PM!

[Nightmare2012]

OK guys I've been doing some reading and it says that the map and maf sensor are different for the ls7&ls3 any truth to this and also tthat the throttle body connection is a bit different and won't clip.

[litle88]

Originally Posted by Nightmare2012

OK guys I've been doing some reading and it says that the map and maf sensor are different for the ls7&ls3 any truth to this and also tthat the throttle body connection is a bit different and won't clip.

The LS7 intake won't accept the larger-diameter LS3 MAP sensor, so an LS7 MAP sensor connector needs to be wired into the LS3 harness, and the controller will need to be remapped (in the tune) to the LS7 MAP sensor. Which Tony wil just copy and paste the values no biggie.

[litle88]

You can reuse the TB iirc it's basically the same thing, they are a 4 bolt 90mm

[MikeMoach]

Originally Posted by litle88

I replied sorry but I didn't get a notification of your PM!

It's all good man thank you

[litle88]

Originally Posted by MikeMoach

It's all good man thank you

Mike it's all good bud! What CAI do you have?

That's your car sucking in air. It's the initial rush of air getting sucked in. Sometimes it will make a similar sound when you shut it down.

[thahemp]

My fastlane exhales between gears too. I dig it.

Heritage grill showed up today. Looks like I'll be taking a half day tomorrow to get it installed.

[MikeMoach]

Originally Posted by litle88

Mike it's all good bud! What CAI do you have?

That's your car sucking in air. It's the initial rush of air getting sucked in. Sometimes it will make a similar sound when you shut it down.

I have a CAI intake, I've taken the cover off and had someone rev it for me and can feel air coming out with my hand inside the box

When I rev it like that parked it's only to 1500 RPM but when I'm driving I can feel it up to 2000 RPM and struggle getting to 2nd gear but after that it's like normal

Was never like this before, I don't know if it's connect to me cleaning the throttle body or not but since I sprayed it with the cleaner I've had this trouble

[litle88]

Ok send me a video of a walk thru of your intake and intake manifold along with your catch can set up.

[Nightmare2012]

Originally Posted by litle88

The LS7 intake won't accept the larger-diameter LS3 MAP sensor, so an LS7 MAP sensor connector needs to be wired into the LS3 harness, and the controller will need to be remapped (in the tune) to the LS7 MAP sensor. Which Tony wil just copy and paste the values no biggie.

Thanks bud!

[MikeMoach]

Originally Posted by litle88

Ok send me a video of a walk thru of your intake and intake manifold along with your catch can set up.

Ok I'll take a video of someone else revving and I'll be in the engine bay and show you everything, but it'll have to be tomorrow

Thanks again bud!