Angel Eye Mod (93-97 Camaros)

[CamaroSpike23]

Originally Posted by Bang Camaro

did mine last night... stocks blew out so i went 4 it... but im using pilots

pics?

[Bang Camaro]

[Bang Camaro]

i will get night shots once i get the car running

[zebra]

just one set?

[Bang Camaro]

Originally Posted by zebra

just one set?

for now... i was trying to find the same type but smaller for the high beams but couldn't, so i will install the other set next week... and besides, i thonk it looks pretty cool with 1 set

[urugm21]

wait is ron is that ur car?

[Bang Camaro]

Originally Posted by urugm21

wait is ron is that ur car?

yes man, yes it is. and thats my whip

[Bang Camaro]

[Squeekiejay]

Originally Posted by Bang Camaro

Are those the same headlights the his first link goes to?
And can you see the brightlight's halos with the low beams on?

[CamaroSpike23]

Originally Posted by Squeekiejay

Are those the same headlights the his first link goes to?
And can you see the brightlight's halos with the low beams on?

should be.

and yes you can see the halos with the highs and lows on

[Squeekiejay]

Yeah, I went back to the first night pics of the car and could see them pretty good.
Guess I'm gonna Order them if they dont have the halos I can make some. Then all thats left is to paint my front bumper. Then my car is done execpt for the motor.

[CamaroSpike23]

Originally Posted by Squeekiejay

Yeah, I went back to the first night pics of the car and could see them pretty good.
Guess I'm gonna Order them if they dont have the halos I can make some. Then all thats left is to paint my front bumper. Then my car is done execpt for the motor.

cool. any pics?

[DVS_DAN]

Originally Posted by Speed

Ok...here ya go. 1st off let me just start off by saying I am not a professional mechanic nor am I saying that this is better then anybody else's way, its just the way I did it.

I chose to bolt to the header instead of putting screws in my bumper, I used the center hole and used nuts that have a lock washer built on to them, Finding black bolts wasn't easy


Again, even though I'm a solider kind of person and I really do not like these quick connects, I didn't like the idea of cutting off my plugs, so i jumped the high and low hots as shown


I ran the grounds together for high/low beams and for the leds and put them as shown on each side here


or you could go here


As far as the interior led wiring, I already had a switch inside the car that runs some leds in the interior and I just ran to that switch. If you have not made a place to run wires into your Camaro, an easy way is to remove the computer (two 10mm bolts I believe) pull the rubber grommet out of the fire wall, take off the tape on the end, snake a new wire through (maybe use a hanger if needed) and pull the wire through from under the dash, tape back up and put the grommet back in. I was a little hesitant the 1st time i did this also but it was really quite simple. I'm sure everyone has there on ways and who knows which is best, this is just mine. Thanks for the interest and good luck.

I want to get my hands on these pics from last year somehow, PM me if you might have them or can view them.

[White_Knuckle_Tight]

The only thing that would make it better is if you could fabricate a piece of plastic or something to mount right behind the lights to hide everything. But even still, hands down, those are the best AM headlights I've seen on a 93 - 97