![]() |
|
|
#1 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
Lots for Sale (eibach springs, hood, 1 pzero, havoc rockers, oem rockers, etc.)
Howdy, need to get rid of my take off parts and make room. I would prefer to do local pick up on the big things but can try to ship if need be. I'm located in Leavenworth Kansas just north of Kansas City.
All prices are obo since I needed to put prices on things, so offer up. Most likely I will say yes since I just want this stuff gone, if it doesn't sell it'll most likely get junked) Everything was on the car for 16,000. Hood/Trunk/OEM rockers 30,000 Rotors 10 miles, yes ten Havoc Rockers under 2,000 Eibach Springs 10,000 Havoc Rockers painted IOM – $300 Up for sale is a set of painted IOM Havoc Side Skirts. They were painted by Gary from Gary’s Customz. They are in excellent shape, the paint is a 100% match to IOM, and they look excellent. They were only on my Camaro for 3,000 miles, no chips of any kind. No drilling required! They install over the OEM rocker panels with 3M Automotive Tape and 5 pushpins in the bottom. Some of the push pins that came with it are a little bent but should be easy to come by. However I will be including a brand new set of these! I know RPI used to sell them painted for $800 shipped. But due to ZL rockers selling fast super low price. Also have stock rockers listed below. ![]() ![]() ![]() ![]() Pirelli Pzero 245/45/ZR20 has less than 30 miles on it. I had a tire blowout and this was the replacement. After that I replaced all 4 and kept this one because it was basically brand new. I guess $130 shipped ![]() ![]() ![]() V6 stock unpainted engine cover $40 shipped V6 RS IOM full front bumper with upper and lower grill as well as DRLs $275 V6 stock struts with Eibach 1" lowering springs $250 IOM stock hood with white stock stripes $275 ![]() ![]() IOM OEM rockers, small chips where the tape from the Havoc skirts peeled $50 (still on the car will be off within the next week, will post photos when it’s off) Also have a 2010 Rear view Mirror replaced it with a frameless one $25 shipped
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR Last edited by Aequitas & Veritas; 02-22-2014 at 12:44 PM. |
|
|
|
|
|
#2 |
|
INFECTED
Drives: 2011 1LT Synergy Green Join Date: May 2011
Location: Upstate PA
Posts: 3,226
|
I call gibs on this 1st....PM Sent . Waiting for reply...
Auto shifter panel $10
__________________
|
|
|
|
|
|
#3 |
![]() Drives: 2013 LS Join Date: May 2013
Location: Nashville
Posts: 679
|
I Just Watched Men At Work Lol.
__________________
|
|
|
|
|
|
#4 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
All pm's replied too
2 people interested in the auto shifter panel piece 2 questions about the spare 1 about the shark fin antenna
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR Last edited by Aequitas & Veritas; 01-19-2014 at 08:16 AM. |
|
|
|
|
|
#5 |
|
BowtieBelle's SS
Drives: 2010 Camaro SS Join Date: Jan 2012
Location: Perry, ok
Posts: 1,075
|
Ill take the SS rotors if you will ship them.
__________________
|
|
|
|
|
|
#6 |
|
Her Name is Mila
Drives: 2012 Camaro 1LT A6, 2014 Camaro 1LS Join Date: May 2012
Location: USA
Posts: 1,324
|
ill take the diffuser
__________________
|
|
|
|
|
|
#7 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
All pm's replied. Lots of interest in the shifter panel piece, 4 people in line. Going by who pm'd me first as that is the most fair. If they fall through then it moves through the line.
The spare tire has gotten a lot of questions. Not sure about shipping just yet but I will try to find out today. It's really freaking heavy, more than a normal tire. But 3 people are in line for that if shipping isn't massive. And just wanted to mention you'd still need a spacer to clear brembos with this as this is just the one you use for the V6 brakes. Done, I'll get a quote for you later today! Not sure how much shipping will be, gotta find a box for it too lol but I'll look into it if you want
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR |
|
|
|
|
|
#8 |
|
Whipped
|
If the rotor sale falls through, I'm in.
__________________
|
|
|
|
|
|
#9 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
Got you down as number 2
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR Last edited by Aequitas & Veritas; 01-13-2014 at 11:34 AM. |
|
|
|
|
|
#10 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
Auto shifter panel has been sold!
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR |
|
|
|
|
|
#11 |
![]() |
I'm interested in the trunk lid...
|
|
|
|
|
|
#12 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
Okay, no idea how shipping on that would be. But I'll pm you when I get it off.
----- As for the rotors looking like it'll be $100 to ship them since they miss the flat rate boxes by 2 inches. So They are $150 shipped, waiting to hear back from the guy in line. ---- Looks to be about $50 to ship the spare tire so $100 total for that, and there are three people in line for that. I'll let you know
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR |
|
|
|
|
|
#13 |
![]() Drives: 2013 ZL1 M6 Join Date: Jun 2013
Location: Baton Rouge, LA
Posts: 328
|
Any idea if the lowering springs would work on a ZL1?
|
|
|
|
|
|
#14 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Camaro 2LT RS, 2009 GTR Join Date: May 2009
Location: Kansas
Posts: 2,559
|
No idea on that front...
__________________
Build thread: http://www.camaro5.com/forums/showthread.php?t=152335
Photos: www.flickr.com/bradbeer GTR Instagram: @NoCrustGTR |
|
|
|
|
|
|
|
![]() |
|
|