You are browsing camaro5 
 |
|
02-20-2014, 06:14 PM
|
#1 |
 |
square set up ZL1
not sure if this has been answered anywhere...but can I run 295/35/20 on all four corners on my Zl1!
|
|
|
|
02-20-2014, 07:46 PM
|
#2 |
   
Drives: 1/70 2013 BRM 2SS RS 1LE NPP NAV Join Date: Feb 2013
Location: Parrish, Florida
Posts: 1,082
|
Yes or you can run 285's all around like 1LE. But the ZL1 suspension has been tuned for the factory staggered tire sizes.
__________________
 |
|
|
|
|
02-20-2014, 09:49 PM
|
#3 |
       
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,824
|
I have aftermarket wheels for the road course that I run 285/35-20 square which have a compromise offset of +30mm. Stock fronts are +23 and stock backs are +37. They seem to work great! I can rotate them front to rear only since the tires are directional but it helps!
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
|
|
|
|
02-22-2014, 01:17 PM
|
#4 |
 Drives: 2013 1SS Join Date: Nov 2013
Location: Durham, NC
Posts: 126
|
How can you rotate with the wheels are 10" and 11" wide?
|
|
|
|
|
02-22-2014, 01:43 PM
|
#5 | ||
|
Captain Gingerbeard
Drives: 2012 IOM RS/SS 6MT Join Date: Mar 2013
Location: West Twin Cities, MN
Posts: 2,489
|
Quote:
Quote:
|
||
|
|
|
|
02-22-2014, 01:49 PM
|
#6 |
|
Drives: 2013 1SS Join Date: Nov 2013
Location: Durham, NC
Posts: 126
|
I had this question for the dealer that said "they were going to rotate my tires". I didn't ask because I didn't want to get pissed after hear lies! I do speak french when I get pissed!
|
|
|
|
|
02-23-2014, 03:30 AM
|
#7 | |
|
Captain Gingerbeard
Drives: 2012 IOM RS/SS 6MT Join Date: Mar 2013
Location: West Twin Cities, MN
Posts: 2,489
|
Quote:
|
|
|
|
|
|
02-26-2014, 12:17 PM
|
#8 |
|
2013 ZL1
Drives: 2013 ZL1 m6 Join Date: Oct 2010
Location: Avondale AZ & Indy will always be home
Posts: 870
|
Has anyone tried fitting the 305s up front on the stock wheels to create a semi square setup that way? Have looked a few times and not found anything mentioning it.
|
|
|
|
|
02-26-2014, 01:48 PM
|
#9 | |
|
Captain Gingerbeard
Drives: 2012 IOM RS/SS 6MT Join Date: Mar 2013
Location: West Twin Cities, MN
Posts: 2,489
|
Quote:
|
|
|
|
|
|
03-02-2014, 02:23 PM
|
#10 | |
 Drives: 2014 ZL1 Join Date: Aug 2010
Location: USA
Posts: 70
|
Quote:
|
|
|
|
|
|
03-02-2014, 11:28 PM
|
#11 | |
|
Speed Freak
Drives: 2013 ZL1 Camaro, 2016 Camaro SS Join Date: Jun 2013
Location: Ardmore, OK
Posts: 2,637
|
Quote:
__________________
2016 SS -AGP twin Borg Warner 7163 EFR's, LT4 mechanical pump, LT4 injectors, Walbro 255 low side, Castrol SRF. 734whp/759 tq
2013 ZL1 -ADM - 427 LSX 6 bolt, O-ringed block built by LME. Twin PT6466 turbos. RPM custom manual trans, RPS Quad carbon clutch, 9" Hendrix rear diff & axles. ADM/squash fuel system, Ron Davis radiator, Spal fans, AGP air to air, turbo plumbing. LPE oil cooler, rear bushing upgrade, roll bar...etc. rwhp 1400+... 212.5mph, best Texas mile to date.  |
|
|
|
|
|
03-03-2014, 06:16 AM
|
#12 | |
|
Drives: '21 ZLE A10 Join Date: May 2012
Location: Mechanicsville, VA
Posts: 6,824
|
Quote:
__________________
'21 ZLE A10 Wild Cherry PDR 2:00.78 VIR Full 10.68@131.69 1.68 60'
'17 ZL1 A10 Mosaic Black PDR/Nav 2:03.08 VIR Full 11.003@129.2 1.75 (sold) '15 Z/28 #325 Black a/c & stereo. 2:10.1 VIR Full (sold) '12 ZL1 A6 Black 10.52@131 1.55 60' 2:13 VIR Full (sold) |
|
|
|
|
|
|
|
|
 |
|
|
