![]() |
|
|
#1 |
![]() ![]() |
Rear overdrive COG belt replacement
There may be a thread on this already, but I could not find it. What is the best way to change out the rear COG drive belt for a TVS2300?
|
|
|
|
|
|
#2 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: V10 BMW M5, Supercharged 2SS/RS Join Date: Jun 2010
Location: Charlotte NC /Brooklyn NY
Posts: 2,305
|
(1) Loosen the set/tension screw at the side of the blower.
(2) Loosen two bolts on the back of the blower between the cogs You should be able to slide the jackshaft with the serpentine still installed to release the tension on the cog belt. Install new belt.
__________________
MAST 416 STROKER: STAGE 3 TVS 2300 CUSTOM CAM TPIS 102 TB IW 8 RIB PULLEY W/ OD COG REARS NX EXPRESS/NANO KIT KDI HEAT EXCHANGER/ROTOFAB RESERVOIR CIRCLE D 2800 TC/FLEX PLATE/ADM TRANS COOLER DSS DRIVESHAFT/1400 HP AXLES EATON TRUETRAC -LPE 3.27 GEARS DYNATECH HEADERS/MAGNAFLOW EXHAUST SQUASH RETURN STYLE FS ID 850's E85/ FLEXFUEL BMR/EIBACH SUSPENSION KILL MODE, ON. |
|
|
|
|
|
#3 | |
![]() ![]() |
Quote:
|
|
|
|
|
|
|
#4 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: V10 BMW M5, Supercharged 2SS/RS Join Date: Jun 2010
Location: Charlotte NC /Brooklyn NY
Posts: 2,305
|
__________________
MAST 416 STROKER: STAGE 3 TVS 2300 CUSTOM CAM TPIS 102 TB IW 8 RIB PULLEY W/ OD COG REARS NX EXPRESS/NANO KIT KDI HEAT EXCHANGER/ROTOFAB RESERVOIR CIRCLE D 2800 TC/FLEX PLATE/ADM TRANS COOLER DSS DRIVESHAFT/1400 HP AXLES EATON TRUETRAC -LPE 3.27 GEARS DYNATECH HEADERS/MAGNAFLOW EXHAUST SQUASH RETURN STYLE FS ID 850's E85/ FLEXFUEL BMR/EIBACH SUSPENSION KILL MODE, ON. |
|
|
|
|
|
#5 |
![]() ![]() |
Ok, I was given the incorrect belt. (too small) Anyone know an aftermarket belt that will fit the overdrive COG? Should be I believe a HTD-600-8M 75 tooth belt but searches have come up empty.
|
|
|
|
|
|
#6 |
![]() ![]() ![]() ![]() ![]() ![]() |
This is the belt i run on mine 6008MGT30
|
|
|
|
|
|
#7 |
![]() ![]() |
Thank you Sir! Found it.
|
|
|
|
|
|
|
|
![]() |
|
|