![]() |
![]() |
#1 |
Account Suspended
Drives: MANual Join Date: Jul 2013
Location: Cape Girardeau
Posts: 505
|
![]()
So to fix my side skirts I will be drilling a hole under the rubber sealant things through the splitter to put a screw into the car to keep it held up. I put the license plate fasteners into the holes in the car that will seat the screw as you can see in the pic.
1) How do I get a hole drilled in the skirt so that it is aligned with hole in car? 2) There are 7 holes that I can put screws in. Should I do all 7 or would that be over kill? |
![]() |
![]() |
![]() |
#2 |
Account Suspended
Drives: MANual Join Date: Jul 2013
Location: Cape Girardeau
Posts: 505
|
Is there a better section this should go in?
|
![]() |
![]() |
![]() |
#3 |
![]() Drives: ZL1 Join Date: Aug 2013
Location: FL
Posts: 83
|
Why don't you get the clips that should be used there? They should go on the rocker and then push into those holes. There's a whole bunch of them.
|
![]() |
![]() |
![]() |
#4 |
Account Suspended
Drives: MANual Join Date: Jul 2013
Location: Cape Girardeau
Posts: 505
|
It's for street scene side skirts no clips come with it only tape.
|
![]() |
![]() |
![]() |
#5 |
![]() Drives: ZL1 Join Date: Aug 2013
Location: FL
Posts: 83
|
Oh ok. I wouldn't do all 7. Every other one would be good.
|
![]() |
![]() |
![]() |
#6 |
Account Suspended
Drives: MANual Join Date: Jul 2013
Location: Cape Girardeau
Posts: 505
|
Ya and if anybody else wondered a guy sent me a message that was a good idea. Put the screw in the side of the car with toothpaste on the end of it then push the skirt against it and you will have a mark of where to drill pilot hole. I'm just gonna put tooth paste on that bracket thing
|
![]() |
![]() |
|
|
![]() |
|
|