12-26-2014, 06:49 PM | #1 |
Camaro King [^*^*^]
Drives: Apollo 11 Camaro IOM Join Date: Dec 2009
Location: CA
Posts: 1,754
|
Razzi Front Install?
so eventually i want to get the razzi front splitter. i am worried about the install because i had a splitter on my car already and i hit it on something and it kind of tore the bottom of my front valance a little bit where the screws were on one side. so i am assuming this one will screw in that same area where i cant put a screw anymore so what can i do?
__________________
|
12-27-2014, 10:33 AM | #2 |
Drives: 2011 2LT RS IOM Convertible Join Date: Dec 2010
Location: Buffalo, NY
Posts: 2,020
|
When I attached mine there were 2 plastic L brackets that mounted inside the front wheel wells. The splitter screwed to those and the only other fastening was done with glue or double sided tape. There were no mechanical fasteners on the bottom. This was on the V6 bumper I don't know if it is different on the V8 bumper.
__________________
|
12-27-2014, 02:23 PM | #3 | |
Camaro King [^*^*^]
Drives: Apollo 11 Camaro IOM Join Date: Dec 2009
Location: CA
Posts: 1,754
|
Quote:
__________________
|
|
01-18-2015, 05:32 PM | #4 |
Drives: 2010 Camaro 2SS/RS Black on Black Join Date: Jan 2010
Location: Virginia
Posts: 212
|
I just installed my yesterday. He is correct. Also search the forums one DIY recommended (and did it) adding a screws or rivets underneath. I did the install with screws. Once everything was perfect I replaced the screws with pop rivets. You can get a rivet gun at any Home Depot or HW store for <$20.00.
Good luck.
__________________
2010 Camaro 2SS/RS
Black on Black Performance Mods: CAI, ADM Scoop, Rotofab Washer Kit, Cat Back Borla ATK, SLP Underdrive Pulley, SCT Tune, DynaTech Long Tube Headers and High Flow Cats. Appearance Mods: Razzi Bodykit with LEDs, 3D Carbon Side Vents, Tint, Painted Rims and Calipers, See/hear my Camaro at http://youtu.be/wn0Ck-cw6WQ |
|
|
|
|