You are browsing camaro5 
 |
|
03-25-2015, 05:54 PM
|
#1 |
      
|
Can't get axle out???
Can't get the axle out of the drivers side. Had a eaton truetrac and 3:45 put in last summer. Pulling it to install a 9in. I have tried everything I can think of. Any ideas? Could it be something with the design of the eaton?
Sent from my iPhone using Tapatalk |
|
|
|
03-25-2015, 05:55 PM
|
#2 |
|
|
 Sent from my iPhone using Tapatalk |
|
|
|
|
03-25-2015, 06:12 PM
|
#3 |
|
Account Suspended
Drives: 2010 zr1 Camaro 2011 vert Join Date: Apr 2013
Location: everywhere
Posts: 1,121
|
Call me and I can walk you through it
|
|
|
|
|
03-26-2015, 06:13 PM
|
#4 |
|
|
The wire clip a bit snug? Never pulled a Camaro axle but most every other axle requires a bit of a tug and maybe pry between the CV housing and center section. It's the quick tug/impulse that gets it
__________________
2010 2SS - CAI Intake, ADM Scoop, RotoFab Washer relo. LT Headers and off-road pipes, X-pipe, Muffler Deletes, ZL1 Spoiler, Technostalgia Tail-lights
'98 T/A (Sold) - Forged 6.0ltr, MS3, P&P'd Heads/Valves, 90MM FAST/TB, Headers, 3" Y-pipe, 4" Mufflex Catback. Koni Adjustables w/GC coilovers (550/175), Strano Sway Bars '94 Z28 (Sold) ... LS1 swap (basically same setup as the T/A), TH350/3500 stall ... swapped it all into the T/A -- >> Some of my Projects My Fquick Page |
|
|
|
|
03-26-2015, 06:33 PM
|
#5 | |
|
Account Suspended
Drives: 2010 zr1 Camaro 2011 vert Join Date: Apr 2013
Location: everywhere
Posts: 1,121
|
Quote:
|
|
|
|
|
|
|
|
|
 |
|
|
