Quad Exhaust for the LFX???

[rozay]

Originally Posted by MLAZ1990

Where'd you get the tips from?

Member here on the forums

Sent from Galaxy Note 4

[MLAZ1990]

Originally Posted by rozay

Member here on the forums

Sent from Galaxy Note 4

Ah damn

[Blu Ray]

Originally Posted by pinoyscorpion951

Yes, I've done it. I have an MRT V2 exhaust and I added quad tips to it. You just need to swap out the rear diffuser to a 1LE/ZL1 diffuser. Yours is a 2013 so the diffuser would be different than mine which is a 2014. I got my quad tips from here:

http://www.ebay.com/itm/STAINLESS-ST...-/271251388875

The other option is getting the GM NPP exhaust setup.

What Size Quad Tips Did you go with to Fit Over the MRT2

Also if you can rember what did the shop charge you to weld them on

[6bangerBOOM]

I've got quad tips as well. Taking off your stock rear diffuser is a major PITA, RE always remember that WD-40 is your friend. If you decide to go this route then keep in mind also that you have to have your exhaust redone. You can't just stick quad tips on because they won't be aligned properly with the diffuser. But it looks so damn good when it's done.

[Blu Ray]

Originally Posted by 6bangerBOOM

I've got quad tips as well. Taking off your stock rear diffuser is a major PITA, RE always remember that WD-40 is your friend. If you decide to go this route then keep in mind also that you have to have your exhaust redone. You can't just stick quad tips on because they won't be aligned properly with the diffuser. But it looks so damn good when it's done.

When you say redone.... what does that all in-tale?

[hzisfrom1994]

Originally Posted by Blu Ray

When you say redone.... what does that all in-tale?

My pics will explain everything you want to know...

If no, basically, they need to cut the axle back and enlarge a little bit the pipe to push it more inside to make the pipes centered, in order to have the quad tips centered and welded.

Good luck!!

[Blu Ray]

Originally Posted by hzisfrom1994

My pics will explain everything you want to know...

If no, basically, they need to cut the axle back and enlarge a little bit the pipe to push it more inside to make the pipes centered, in order to have the quad tips centered and welded.

Good luck!!

I see what was the damage $$$ and have you noticed any deeper sound?

[6bangerBOOM]

Originally Posted by Blu Ray

When you say redone.... what does that all in-tale?

The first pic from hzisfrom1994 shows exactly what I'm talking about. Any "exhaust kit" for the V6 is going to be positioned such that the exhaust lets out to fit the stock V6 diffuser. The 1LE/NPP diffuser extends inwards from the position of the stock exhaust, not equally in both directions. So you can put on the 1LE/NPP diffuser and then slap on some dual tips, because it won't be aligned.

So if you want, for example, Flowmaster American Thunder exhaust then you need to buy only the mufflers from the flowmaster website and then take'm to an exhaust shop.