Drag Wheels Question?

[BandRcAMARO]

So a little backround info. Car is a 2010 SS M6 and is lowered 1.4 inches. Mods are bolt ons and TSP cam and it puts down 470 to the wheels. I ran the car a few tires last season on street tires. 60 foots were awful and I kept getting wheel hop which did not help. I plan on installing BMR toe and trailing arms to help with the wheel hop and then going with 18 inch wheels for the rear with some drag radials.

http://www.sears.com/oe-performance-...Q&gclsrc=aw.ds

I found those wheels that a decent priced and from what I have found in the forums they seem to fit fine. As for tires i dont know what to get i figured i cant go wrong with M/T's or Nittos. Also could i fit the 305/40/18 M/T et streets on those rims? I feel as 9.5 inches wide si too small but then again if i got the 275/45/18 the heights is only 27.8 inches which might set off ABS and stabilitrack errors. Any advice or suggestions would be helpful on which tires or wheels to go with. Thanks

[Pro Stock John]

1. Looks like they would fit, check the sticky I put together.

2. M/T better than NT05R.

3. You should install offset diff bushings will help keep the CV joints in your axles alive. I got mine from Hendrix.

4. For the shorter tire you might need to pull the ABS fuses, I'm not 100% sure.

Replicas + NT05R 305/45/18


Hendrix Engineering Offset Bushings: