![]() |
|
|
#1 | ||
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
Power Loss w High Fluttering Idle
Hi.
I have reduced power, poor economy and a bad idle. I have come here seeking suggestions or ideas. There is some necessary backstory to this however. These issues began immediately after I serviced my AC compressor belt. It was squealing - dislodged its tracks. I did this from the top, not from below (which I now regret) meaning I took off my air intake manifold and serpentine belt. I disconnected my MAF and pcv hose in the process. Note that the first time I started the car after servicing my belts I left my MAF disconnected. I tried blowing on my MAF with compressed air as in hopes that would help but it had no effect. I have a couple other ideas but I thought I would come here first.After the self-service I had a CEL (P0113) which was for air intake temperature circuit. I have had this looked at by a dealership and they said it was okay and cleared the code for me. However, the issues of reduced power, poor economy and a bad idle still persist. (Bad idle means that the tach and engine rpm flutters). I asked local dealership mechanic about the bad idle but he couldn't offer a straight answer. He advised me to not waste money on the issue as "old cars get this way". With this being said, the loss in power and weird idle are NOT NORMAL, especially since the symptoms occurred immediately after I tired self servicing my belts. Fluttering Idle when hot Let my car sit overnight to cool and the idle is very high but drops down eventually as it heats This vehicle is a bone stock 2011 V8. |
||
|
|
|
|
|
#2 |
![]() ![]() Drives: 2013 Camaro SS Join Date: Feb 2017
Location: Indiana
Posts: 901
|
Have you tried disconnecting the battery.
|
|
|
|
|
|
#3 |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
Yes, I did before going to the dealership but I will do it again tonight when I get access to wrenches.
You're thinking MAF reset? |
|
|
|
|
|
#4 |
![]() ![]() Drives: 2013 Camaro SS Join Date: Feb 2017
Location: Indiana
Posts: 901
|
Yeah, are you sure you put the maf in the right way?
|
|
|
|
|
|
#5 |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
|
|
|
|
|
|
#6 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Inferno Orange 2SS/RS Join Date: Apr 2010
Location: Clermont, IN
Posts: 3,297
|
Idle looks normal.
__________________
2010 Inferno Orange 2SS/RS M6 Black Leather, Sun Roof, OBX Headers, Borla touring axle back, Cold Air Inductions CAI , non synthetic fluids, BMR total bushing upgrade/1" lowering springs, DSE 32mm rear sway bar. GM fe4 shocks/struts/LCA's, AAM 3.91 diff, Vertini RFS1.8 20x9 +30. Conti ExtremeContact Sport 275/35/20. sjm autoprod ABL dash kit. Mike Norris tuned 413/419.
Avenging Orange: 43 years of not buying into the Hype........and damn proud of it!! https://youtu.be/9JD9it6SmB8 https://youtu.be/xmelTlEzI34 KICKING CANCERS ASS SINCE 2015!! |
|
|
|
|
|
#7 |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
|
|
|
|
|
|
#8 |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
Hi thanks for your reply.
But how would you explain: Vehicle surge at low rpm? Bad mileage? Don't know exactly what mileage I'm getting right now but will check now by setting a mile counter. This only started for me after servicing my belts. How many stock camaros do you know of with similar idle? I was thinkig maybe a vacuum leak at the pcv somewhere. The issues with vacuum leak are all consistent. |
|
|
|
|
|
#9 |
![]() Drives: 2011 2SS/RS CGM Join Date: Dec 2012
Location: Fort Worth, TX
Posts: 84
|
All of the symptoms sound like your MAF sensor went bad. Might need to replace it. A little over $50 from Amazon.
__________________
Too many mods... Or perhaps not enough. Just one more.
|
|
|
|
|
|
#10 |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 CGM 2SS/RS LS3 Swapped A6 Join Date: Sep 2016
Location: Spring Hill, FL
Posts: 4,735
|
When you left the MAF disconnected on accident, is it possible it got caught up in the belts or rubbed against a pulley when you started it? Did you check the entire MAF cable?
I have done this before myself and have come very close to getting my entire MAF cable ripped apart.
__________________
2010 CGM Camaro 2SS LS3 Swapped A6 - GPI LS3 SS1 .647/.638, (224/237, 112 +4, 7º overlap) on CamMotion 8620 core, BTR Platinum .660" Dual Spring kit w/titanium retainers, CHE bronze trunnion upgrade, stock heads milled @ .015, Melling HV 10296 oil pump, TSP 1-7/8" long tube headers (W/Catless Off-road Pipes), Corsa Xtreme 3" Catback, GPI Ported/Rod Mod Intake, Stage 2 Ported Throttle Body, Vararam OTR CAI, Mike Norris Gen 2 catch can + GM 1LE clean side separator, 160º thermostat - Megan Racing adjustable coilovers (lowered 1.75"), MRR M017 10/11" wheels-Tuned by Ryan @ GPI
|
|
|
|
|
|
#11 | |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
Quote:
Did you just go to a service center and ask them to rewire it? |
|
|
|
|
|
|
#12 |
![]() Drives: --- Join Date: Sep 2013
Location: Canada
Posts: 29
|
Could not find a clip however found this. This would be what I need if I was to redo wiring correct?
http://www.gmpartsdepot.ca/a/Chevrol...L/CD10200.html |
|
|
|
|
|
#13 | |
![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() Drives: 2010 Inferno Orange 2SS/RS Join Date: Apr 2010
Location: Clermont, IN
Posts: 3,297
|
Quote:
As always....I recommend eliminating the obvious. Check all connections....clean your maf and give the computer some miles to adjust.
__________________
2010 Inferno Orange 2SS/RS M6 Black Leather, Sun Roof, OBX Headers, Borla touring axle back, Cold Air Inductions CAI , non synthetic fluids, BMR total bushing upgrade/1" lowering springs, DSE 32mm rear sway bar. GM fe4 shocks/struts/LCA's, AAM 3.91 diff, Vertini RFS1.8 20x9 +30. Conti ExtremeContact Sport 275/35/20. sjm autoprod ABL dash kit. Mike Norris tuned 413/419.
Avenging Orange: 43 years of not buying into the Hype........and damn proud of it!! https://youtu.be/9JD9it6SmB8 https://youtu.be/xmelTlEzI34 KICKING CANCERS ASS SINCE 2015!! |
|
|
|
|
|
|
#14 |
|
Resident nomad
Drives: 2014 Summit White 1SS/1LE Join Date: Nov 2015
Location: Gilbert, AZ
Posts: 1,765
|
Agree with this^. That tach signal "flutter" seems normal, as does the cold start readings. Since you haven't really described the "lack of power" or the mileage drop, hard to quantify that....
__________________
Sold:
2007 Z06 2002 Viper GTS/ACR 2003 Z06 1965 FFR Cobra 2012 Nissan 370Z ADM LSA Stage II, Roto-Fab CAI, Kooks LTH/HFC's, Phastek CC, ported TB, Mishimoto radiator and oil cooler, BC Racing ER Series CO's, JPSS 32mm Black Magic rear bar, JPSS front inserts, R1 Concepts Premier slotted rotors/Goodrich SS lines, Schroth ASM harness, MGW flatstick, Brey-Krause HB, Tuned by NicD, at Cordes Performance Racing. |
|
|
|
|
|
|
|
![]() |
|
|