Pedders help ! - Page 2 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

toilets · 08-09-2011, 09:30 AM

alssiri, How did you get this fixed? Did you have to remove the assembly or where you able to fit it back on and loctite it?

Mine happened last night however its dangling but still in the drilled whole. Just not connected to anything.

Thanks

JusticePete · 08-09-2011, 10:12 AM

You can replace the assembly on the car if your allen wrench is long enough. Before you take anything apart, make sure the allen screw is still in the cap.

toilets · 08-09-2011, 10:36 AM

I think the set screw is still in the assembly. I think just the extender fell off the set screw.

JusticePete · 08-09-2011, 12:06 PM

Quote:

Originally Posted by toilets

I think the set screw is still in the assembly. I think just the extender fell off the set screw.

Hopefully the alignment shop will have a long allen wrench.

1. Loosen the set screw on the cable side of the cap that has fallen off.
2. Remove the set screw fro the adjuster side of the cap.
3. LocTite the adjustment screw and set the cap to the adjusting knob. Make sure it is tight.
4. LocTite the set screw for the cable side and insert it into the cap.
5. Thread the cable back into position.
6. Tighten the set screw.

We remove the cable to make it easier to re-attach the cap. If you can re-attach the cap without removing the cable you have made life easier.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
5th Gen Suspension -- The Book	JusticePete	Suspension / Brakes / Chassis	151	05-07-2015 06:52 PM
Pedders Xa Coilovers and Springs \| In stock \| Free Shipping \| Best Prices	JDP Motorsports	Suspension / Chassis / Brakes	115	02-16-2015 09:42 PM
Major Pedders Event in Houston! Saturday, Jan 30th! Meet DMS	Info@PeddersUSA.com	USA - Texas	39	02-01-2010 01:48 PM
Major Pedders Event in Houston! Saturday, Jan 30th! Meet DMS	Info@PeddersUSA.com	USA - Texas	9	01-11-2010 06:55 PM

08-09-2011, 09:30 AM	#15
toilets Drives: 2010 camaro Join Date: May 2011 Location: Southeast, Posts: 842	alssiri, How did you get this fixed? Did you have to remove the assembly or where you able to fit it back on and loctite it? Mine happened last night however its dangling but still in the drilled whole. Just not connected to anything. Thanks

08-09-2011, 10:12 AM	#16
JusticePete Drives: Camaro Justice Join Date: Jun 2007 Location: Virginia Posts: 20,171	You can replace the assembly on the car if your allen wrench is long enough. Before you take anything apart, make sure the allen screw is still in the cap.

08-09-2011, 10:36 AM	#17
toilets Drives: 2010 camaro Join Date: May 2011 Location: Southeast, Posts: 842	I think the set screw is still in the assembly. I think just the extender fell off the set screw.