Apex LLT/LFX Catch Can pictures

[Goran]

Originally Posted by Apex Chase

It is never too late. The way the automotive manufacturers deal with this issue is that they recommend you come in every 15,000-20,000 miles and pay the service department a few hundred dollars to clean it up. You can always go have that done and then install your catch can.

Well I just placed my order for one... and honestly I can't wait ... Will be posting some pics in here, as soon as I get it installed

Thanks again for your advice!

[Apex Motorsports]

Originally Posted by Goran

Well I just placed my order for one... and honestly I can't wait ... Will be posting some pics in here, as soon as I get it installed

Thanks again for your advice!

No problem. Thank you for your order.

[mpiersd]

How does this work compared to the RX can. My RX is plumbed inline between the back of the valve cover and the inlet on the intake.
It looks like this one only has an inlet and no outlet to the intake.

[Apex Motorsports]

Originally Posted by mpiersd

How does this work compared to the RX can. My RX is plumbed inline between the back of the valve cover and the inlet on the intake.
It looks like this one only has an inlet and no outlet to the intake.

All catch cans hook up the same, it is just that our outlets are on the side of the can rather than on top like RX. I did not notice it until you pointed it out but it is obscured in those pictures.

[ChadG]

Originally Posted by Apex Chase

We have not had a chance to do any measuring or test fitting on a Vararam equipped car yet.

Sounds like you need to make a trip to CA!

[shadycamaro]

Just my opinion... don't care for the mounting location/bracket used. To me my alternate vendor can looks more factory/stealth from rear position mounting.

Is there any reason/benefit behind the front location mounting?

Sent from my VS980 4G using Tapatalk

[Apex Motorsports]

Originally Posted by ChadG

Sounds like you need to make a trip to CA!

Not a bad idea.

Originally Posted by shadycamaro

Just my opinion... don't care for the mounting location/bracket used. To me my alternate vendor can looks more factory/stealth from rear position mounting.

Is there any reason/benefit behind the front location mounting?

From a aesthetic standpoint you can not please everyone so we were aiming for a clean look that was not too flashy but was clearly not a stock part either. Something that would be at home under the hood of a bolt on street car or a full show car. That mounting location was chosen because it offered more stability and was easier to access.