You are browsing camaro5 
 |
|
03-11-2011, 03:35 PM
|
#15 |
|
Account Suspended
Drives: SuperCharged 2SS/RS IOM MN6 Join Date: May 2009
Location: CA
Posts: 5,094
|
Use clear silicone to glue it back. It is water resistant and will be on there good. Put a good amount and whatever gets squeezed out when you install the strip, you wipe off. Use masking tape to hold the strip until the silicone is fully cured. You MUST let it fully cure. When I built my Factory Five Roadster (in the pic), this is what I used on all the weatherstripping, emblems, gaps, etc. Any local parts store has it. It comes in a tube.
|
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Camaro Exterior and Interior Stainless Steel Trim Parts from RPI Designs! | RPI Designs | Cosmetics and Lighting Modification Discussions | 36 | 04-02-2020 05:32 PM |
| Camaro Product Manager - interview | Moose | 5th Gen Camaro SS LS LT General Discussions | 11 | 04-04-2012 06:10 PM |
| GM memo to dealers | Moose | 5th Gen Camaro SS LS LT General Discussions | 41 | 02-04-2010 07:33 PM |
| Official Camaro Convertible CONCEPT Press Release | Tran | Camaro Convertible Forum | 12 | 11-18-2009 07:05 PM |
| Camaro (concept) Press Release!! | Pencil.Fight | 5th Gen Camaro SS LS LT General Discussions | 4 | 07-21-2008 03:33 PM |
