Removing factory BA amp

[VeeGeeTea]

Originally Posted by Steve@********

The amp does all the processing. Cleansweep is optional, but not required. X3 is your your input signal. ie audio signal from your head unit to the amp. Plus the turn-on wire and an amp control wire that is orange. X2 is wires leading to all your door speakers and center speaker I believe. X1 is wires leading to your rear 6x9s and the power and ground for the amp.

Once you have our x3 rca harness for your audio signal input, you will also need to conect all the speaker leads on the 4 channel amp back to the x1 and x2 wires in the harness. To do this you will need to splice in. OR just run new wires to all the speakers, but that might not be too easy. Now if you also had our x1 and x2 harnesses, you could interface every wire in the harness with an easy connection and not splice or solder anything. Like in this pic..



But again, we haven't gotten enough interest to justify ordering easy connect harnesses for x1 and x2. Which is too bad because this would make interfacing a 4 channel amp back into the factory wiring very easy.

Steve, I recently ordered the v3.0 of the harness.
Do you still make the X1? Thanks.