Cheapest mods you have made to your camaro <$100

[Aubrey64]

Dyed stitching- $3
Aftermarket Paddle Shifters- $95
Painted Engine Cover- $20
Blacked Out Bowtie- $9
Custom Embroidered RS headrest- $50
Painted Break Calipers- $50

[SimpleGreen]

Had my windows tinted. 20% on the sides and rear plus a strip on the windshield.

$80

[VVXXXVV]

Originally Posted by ihaveacamaro

Made this mod a few months ago for the wonderful price of free

That actually sounds good! i had a v6 mustang that couldnt even comd close to that, now i have an ss camaro muffler delete and it sounds amazing cost 150,

[RubyCamaro]

Here are a couple more:
Window decals 3 at $6 each - free is you have a good friend
Signatures..............priceless!

[horizon670]

I can see our Paddle Shifters Mod !

Here are more details for anyone interested in our Paddles, they will add more fun to your driving for less than $100 shipped to your door.

http://www.camaro5.com/forums/showthread.php?t=221333

[shan1997]

Plastidip the bezzle's, bowties and camaro signs on each side $10.00

[JOHNSONROD]

separate clutch reservoir. it made a huge difference in shifting and the clutch doesnt ever stick down or smell any more. cost less than 25 bucks but my father-in-law gave me a corvette reservoir. it would have still been under 100.

[IOM Black Diamond]

I love this thread lets get it going again

[14pilot]

Put some vinyl over the gold bowtie's. Cost under $20.


and...

[tjk_art]

Swapped:

Rubber knob for a leather knob $40
Auto shifter for a manual leather boot $60

In drive:

[Ace1USMC]

I also did a clutch fluid reservoir mod - actually, several... I went to a junkyard and pulled the reservoir off of a Toyota for $10. I also got a braided steel brake line from a desert runner with -4AN fittings on it ($59) to replace the crappy factory hard line with the crap rubber section. Found a site that makes fittings that will convert the o-ring/clip fitting on our cars to a -4AN fitting ($39/ea). Then I cut the factory hard line coming out of the slave cylinder, added a -4AN compression fitting, ran it into a McLeod line launch clutch solenoid (ok, this was way over $100 at $238). I then wired up some inexpensive switches I found online at Jegs.com for $50. I used a 40-amp buss I made that is relay-activated. I ran this power buss into the console, then made 5 independent, fused circuits. I got a shifter ball with a momentary switch for $62, and one more switch - a Hurst roll control switch for $23. I fabricated a simple plate to mount the switches under the stereo (I hadda sacrifice the little bin in the Metra dash kit) Here's how it all came together...

[Dyk-NO]

Footwell lighting, <40$

[SgtPickles69]

Originally Posted by tjk_art

Swapped:

Rubber knob for a leather knob $40
Auto shifter for a manual leather boot $60

In drive:

Where did you get them for that price?

[TSSUNAMI]

Full tank of Sunoco 93.

JK

Used the member's marketplace on these forums to purchase custom painted CGM bowties. 50 bucks for front and rear.