trunk lid vibration - Page 6 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

Asian Zero · 01-24-2013, 12:54 PM

For those of you who couldnt see where the weatherstripping is heres the pic

Name: 100_0062.jpg
Views: 1095
Size: 185.4 KB

DJ ATOMIX · 02-06-2013, 09:54 PM

Quote:

Originally Posted by coolcamaroZ28

I had this same problem after adding a ******** system to my 2SS. I tried dynamating the trunklid (under the carpet of course) and it helped a little, but there was still rattling from the trunk where it meets the window and applying the slightest amount of pressure in the center would stop the rattle. I installed a thin piece of self-stick weatherstripping I got at Home Depot and it worked - no more rattles!

Wow I have had this problem as well for over two years! I did the same thing to solve this issue and it works great BUT... the stupid weatherstripping eventually falls off, maybe I need to superglue it on next time :( 4 tens in the trunk make my trunk wanna pop open when they are blasting! Good thing our trunks latch is very durable.

Shaun

SummoneR · 02-06-2013, 10:14 PM

I had an issue with the weather stripping allowing water into my trunk, and it later would not allow me to fully close the trunk, for whatever reason it just stopped latching, I looked and everything seemed fine, but I removed the weather stripping and it started latching again... I plan to use smaller weather stripping next. I still need to dynamat the rear deck...

Jodean · 02-13-2013, 10:47 PM

This helped a ton! Why are you guys only doing part of the trunk lid?? Are you that worried about the look on the inside of the trunk lid?? I say stop the noise, who cares what the inside of the lid looks like, its quite dark in there anyway.....

BTW, the thickness of the dynamat at the weather seal locations helps with sealing and rattle, other strip may not be needed then

It was only 40* in the garage, will iron things out when it gets warm out....

jeepguy_1980 · 02-13-2013, 11:14 PM

Quote:

Originally Posted by Jodean

This helped a ton! Why are you guys only doing part of the trunk lid?? Are you that worried about the look on the inside of the trunk lid?? I say stop the noise, who cares what the inside of the lid looks like, its quite dark in there anyway.....

I think that looks terrible, especially the big tear you have.

Jodean · 02-15-2013, 12:29 AM

Quote:

Originally Posted by jeepguy_1980

I think that looks terrible, especially the big tear you have.

tear??

xinfamousxi · 10-15-2014, 04:30 PM

I have a 2013 so I'm assuming the best course of action is

1. buy subwoofer and amp
2. install
3If there are rattles try the following in order

Stripping on trunk

still rattle

Dynomat deck

still rattle

Dynomat whole trunk

02-06-2013, 10:14 PM	#73
SummoneR Paul Drives: '10 2SS/RS M6 "Marauder" Join Date: Mar 2009 Location: NOR*CAL Posts: 6,230	I had an issue with the weather stripping allowing water into my trunk, and it later would not allow me to fully close the trunk, for whatever reason it just stopped latching, I looked and everything seemed fine, but I removed the weather stripping and it started latching again... I plan to use smaller weather stripping next. I still need to dynamat the rear deck... __________________

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to remove the cover on the underside of the trunk lid?	spectrepig	Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum	7	12-23-2009 10:26 AM
Trunk Lid Rattle	Slake	Camaro Issues / Problems \| Warranty Discussions \| TSB and Recalls	4	10-18-2009 03:07 PM
trunk lid issues	nards444	5th Gen Camaro SS LS LT General Discussions	7	09-11-2009 10:00 AM
Gap below trunk lid	scorpio	5th Gen Camaro SS LS LT General Discussions	8	09-24-2008 10:09 AM

01-24-2013, 12:54 PM	#71
Asian Zero Drives: 2010 IBM Camaro 1LT RS Join Date: Sep 2010 Location: Lake in the Hills, Illinois Posts: 418	For those of you who couldnt see where the weatherstripping is heres the pic

02-13-2013, 10:47 PM	#74
Jodean Drives: 2010 Camero 2SS RS Join Date: Oct 2011 Location: Tea SD Posts: 61	This helped a ton! Why are you guys only doing part of the trunk lid?? Are you that worried about the look on the inside of the trunk lid?? I say stop the noise, who cares what the inside of the lid looks like, its quite dark in there anyway..... BTW, the thickness of the dynamat at the weather seal locations helps with sealing and rattle, other strip may not be needed then It was only 40* in the garage, will iron things out when it gets warm out....

10-15-2014, 04:30 PM	#77
xinfamousxi Drives: Camaro 1SS 1LE Join Date: Sep 2014 Location: United States Posts: 481	I have a 2013 so I'm assuming the best course of action is 1. buy subwoofer and amp 2. install 3If there are rattles try the following in order Stripping on trunk still rattle Dynomat deck still rattle Dynomat whole trunk