You are browsing camaro5 
 |
|
11-13-2010, 10:24 PM
|
#1 |
   
|
stock 2010 ss clutch tolerances
2010 2SS/RS, 1 7/8" ARH and 3 inch exhaust,SLP loudmouth II, pending edelbrock supercharger.
I've been hearing a lot about needing to upgrade the clutch if you modify past a certain point. What is that point? Does anyone know how much torque the stock clutch can hold. The Fidanza 6.5 twin plate is what I'm looking at doin if I need to. When my modification is done I'll be around 600hp at the flywheel and probably a little over 500 torque. Do I need to upgrade at that? |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY : Install underdrive pulley on 2010 Camaro SS | Nine Ball | Camaro DIY & HOW-TO instructions & discussions | 34 | 09-30-2013 09:25 PM |
| Stock 2010 Camaro SS Mufflers | Hicompression | V8 - Engine, Exhaust, Bolt-Ons, Tuning Equipment | 10 | 01-30-2011 03:15 PM |
| Over 230 Satisfied 2010 Camaro Customers! Paddock Chevrolet has 40 in stock NOW | camarojoe | Dealer Camaros for Sale | 2 | 05-24-2010 06:58 PM |
| C&D: 2010 Lingenfelter Camaro SS shootout with 2010 Roush Ford Mustang Stage 3 | Tran | 5th Gen Camaro SS LS LT General Discussions | 101 | 03-25-2010 02:37 PM |
| Lingenfelter 2010 LS3 Camaro SS Chassis Dyno Stock | Crowley | Camaro Photos | Spyshots | Video | Media Gallery | 5 | 06-23-2009 02:56 PM |
