02-27-2011, 11:57 AM | #1 |
Drives: MMX Camaro 2LT RS Join Date: May 2010
Location: Indianapolis
Posts: 71
|
How to unplug ABL wiring harness
Trying to do some wiring to swap out the LEDs on my door ABL. Was going to slice into the wiring just being the plastic holder for the LED/resistor but would prefer putting my own wiring in or slicing further down the wire. Came across this connection and am not sure how to disconnect it. Any tips?
__________________
Selene: 2010 RJT/2Tone 2LT RS A6
Blackout Front/Rear Bowties, RS badging INJEN Power-Flow Intake MRT v2 Axle-back Exhaust VMax Spiral-ported TB; VMax Ice-olator Vitesse Throttle Controller RX Catch-Can RJT Eibach Sway Bars AAC Plasma LED DRLs; Sequential Turn Signals Black Gill Inserts; Red-swapped Door and Dash ABL |
02-27-2011, 12:50 PM | #2 |
Drives: 2014 Z/28 #82+#192, 18ZLE 66Nova Join Date: Oct 2008
Location: By the lake in AZ
Posts: 15,719
|
On the one side you will see a slice in it, all you do is stick a small flt head in there, and lift and pull them apart.
|
02-27-2011, 01:04 PM | #3 |
Drives: MMX Camaro 2LT RS Join Date: May 2010
Location: Indianapolis
Posts: 71
|
Thanks, I just didn't want to force it if it wasn't meant to be.
__________________
Selene: 2010 RJT/2Tone 2LT RS A6
Blackout Front/Rear Bowties, RS badging INJEN Power-Flow Intake MRT v2 Axle-back Exhaust VMax Spiral-ported TB; VMax Ice-olator Vitesse Throttle Controller RX Catch-Can RJT Eibach Sway Bars AAC Plasma LED DRLs; Sequential Turn Signals Black Gill Inserts; Red-swapped Door and Dash ABL |
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ambient Lighting (ABL) development summary | McGruff | 5th Gen Camaro SS LS LT General Discussions | 77 | 03-27-2012 12:27 AM |
HUD wiring harness | 2SSRS@Gen5diy | Interior Parts & Accessories | 79 | 01-30-2011 11:28 AM |
Anyone have picts/info on the factory infotainment system wiring harness & plugs? | Matt'sSS | Audio, Video, Bluetooth, Navigation, Radar, Electronics Forum | 3 | 10-01-2009 12:48 AM |