You are browsing camaro5 
 |
|
05-20-2014, 10:25 AM
|
#1 |
 
Drives: 2012 Camaro RS/SS LS3 Join Date: May 2012
Location: North Carolina
Posts: 105
|
HOW much for clear plastic?!?
Okay, so on the body (rocker panel) at the trailing edge of our doors is a small piece of clear plastic that protects this edge. (There's also a piece down underneath the rocker both behind the front wheel and in front of the rear wheel).
The one at the door edge had lifted a little on mine and had collected a good bit of dirt, and being yellow, it was fairly noticeable. So no problem, I just went ahead and removed it. Now months later I'm realizing what GM Engineers already knew... that without it, this hard edge takes a beating from little rocks, etc. that the front wheel picks up. Okay, no problem, I'll just replace them. Called my local dealer and I'm told they cost $55 EACH SIDE! It's literally just a tiny clear plastic sticker! Does anyone know the part number for this so I can confirm they're quoting me the right thing? (or has anyone else run into this issue)?
__________________
The Super-Devil is at least 6 inches taller, has a flying motorcycle and a jar of marmalade that we believe forces you to commit adultery.
|
|
|
|
05-20-2014, 06:28 PM
|
#2 |
  Drives: 2010 Camaro 2SS/RS LS3 Join Date: Oct 2013
Location: Kernersville, NC
Posts: 930
|
If you know the part number go to GM Parts Direct should be much cheaper
|
|
|
|
|
05-20-2014, 06:48 PM
|
#3 |
 
Drives: 2013 2SS/RS/1LE Join Date: Mar 2013
Location: CT
Posts: 483
|
Get a small roll of xpel ultimate film or 3m from Amazon for cheap, trim to size and install yourself. You could try the spray-on paint protection film too but I haven't read good things about that stuff.
__________________
 |
|
|
|
|
|
|
|
 |
| Tags |
| clear plastic, guard, rocker, shield |
|
|
