Factory catch cup - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

Late Camaro · 12-26-2014, 05:36 PM

Looking for some experience on the 1LE catch cup that replaces the screw on oil fill cap. I installed a scoop/CAI, with an Apex catch can. Before heat shrinking the valve cover vent on, I swapped it out for the factory 1LE piece, so now I have two cans. Does anybody have any experience with this set-up? The car is only a week old, so it should be clean (36 miles), it will sit until warm weather gets to Ohio, then it will be 90% street! with a little track and 1/4 mile time for fun. Thanks for your time. Later

extraurban · 12-26-2014, 07:24 PM

Factory catch is for the "clean side", and your Apex piece is for the "dirty side"
Both work independently of each other and your setup is what most run if they have the factory separator too.

12-26-2014, 05:36 PM	#1
Late Camaro Drives: 15 BVM 2SS/RS 1LE NPP Join Date: Aug 2014 Location: Central Ohio Posts: 6	Factory catch cup Looking for some experience on the 1LE catch cup that replaces the screw on oil fill cap. I installed a scoop/CAI, with an Apex catch can. Before heat shrinking the valve cover vent on, I swapped it out for the factory 1LE piece, so now I have two cans. Does anybody have any experience with this set-up? The car is only a week old, so it should be clean (36 miles), it will sit until warm weather gets to Ohio, then it will be 90% street! with a little track and 1/4 mile time for fun. Thanks for your time. Later

12-26-2014, 07:24 PM	#2
extraurban Drives: Junker Join Date: Sep 2014 Location: north, eh Posts: 52	Factory catch is for the "clean side", and your Apex piece is for the "dirty side" Both work independently of each other and your setup is what most run if they have the factory separator too.