Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com
 
Vararam
Go Back   Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums - Camaro5.com > Technical Camaro Topics > Cosmetics and Lighting Modification Discussions


Reply
 
Thread Tools
Old 09-14-2009, 11:12 PM   #1
tjd24
Thank you Oshawa/St.Cats!
 
tjd24's Avatar
 
Drives: was 2010 2LT RS 2G1FC1EV4A9103434
Join Date: May 2009
Location: NW NJ
Posts: 3,481
Rear License Plate LED Mod

Just installed LEDs for the rear License Plate lights -

NOTE - you need two (2) Bulb 194 w/5 LED Matrix White Single as there are two housings. I will not recommend where I got them as it took 3 weeks to get with no feedback & several attempts to email for status then they just showed up. These run $7.99-$8.99 each.

The white matches well to the HID Halos - observe local/State laws if you consider another color.

Installing the Interior / Trunk LEDs from Advanced Auto Concepts when the arrive - http://www.automotivelightstore.com/...ROD&ProdID=457 - Note - just saw they carry the 194 LED so that's a better choice...http://www.automotivelightstore.com/...ROD&ProdID=305... opt for the 5 LED.

Before & After Pics
Attached Images
  
__________________
#3434 Born 4-15-2009, Delivered 5-22-2009 BBOMG 2/3/4 - Traded-in 8/31/2019:
tjd24 is offline   Reply With Quote
Old 09-15-2009, 07:11 AM   #2
skisax80
 
Drives: 2010 camaro ss/rs
Join Date: Aug 2009
Location: dothan al
Posts: 89
i do like that.. was this just plug n play?
skisax80 is offline   Reply With Quote
Old 09-15-2009, 11:14 AM   #3
tjd24
Thank you Oshawa/St.Cats!
 
tjd24's Avatar
 
Drives: was 2010 2LT RS 2G1FC1EV4A9103434
Join Date: May 2009
Location: NW NJ
Posts: 3,481
Quote:
Originally Posted by skisax80 View Post
i do like that.. was this just plug n play?
Yes - its plug & play - better to do in the daylight with the lights OFF as the bulb you'll be removing is quite hot if the lights are on (with lights on use a paper towel or clean rag to remove the stock 194 bulb):

1) there is a clip at the left end of the housing - push to right and the housing should start to come down, you may have wiggle the clip to get the housing moving.

2) housing will pull out with the wires still attached to the socket, gently turn the socket to remove it from the housing.

3) Remove stock 194 bulb by pulling straight out. Replace with 194 LED, push in until tight. Re-connect socket with housing, turning socket until it locks in the housing

4) Re-seat housing in the bumper, clip goes on the left, until housing is flush & secure.

5) Repeat 1-4 with the other side. REMEMBER - there are two (2) bulbs/housing so you need to be sure you order two 194s from wherever you purchase.

Took 5 minutes to complete. I retained the old 194 blubs in the box where I keep the growing number of stock parts I've removed.
__________________
#3434 Born 4-15-2009, Delivered 5-22-2009 BBOMG 2/3/4 - Traded-in 8/31/2019:
tjd24 is offline   Reply With Quote
Old 09-15-2009, 11:20 AM   #4
The Dark Knight
Batmobile in Disguise
 
The Dark Knight's Avatar
 
Drives: 2009 Pontiac G8
Join Date: Aug 2008
Location: Upland, Ca
Posts: 2,079
Hmmm...I might try this when my custom plates come in...
__________________
The Dark Knight is offline   Reply With Quote
Old 09-21-2009, 12:53 PM   #5
DJ ATOMIX
<< CRAZY BEE >>
 
DJ ATOMIX's Avatar
 
Drives: 400HP 2LT/RS
Join Date: Apr 2009
Location: Alberta
Posts: 1,156
JB Power Centre sells these LEDs for $13 plus tax. I just picked up two bulbs for the $13 and I'm headed outside to install them. I cant wait to see them tonight when its dark out!



Shaun
__________________

CRAZY BEE - IOM 2LT/RS (more)
Cosmetic Mods - 24 | Performance Mods - 14
ROTO-FAB CAI - DT HEADERS - CUSTOM 3-INCH PIPE EXHAUST - RES DEL - R-CATS DEL - MAGNAFLOW RES X-PIPE - 91 OCTANE TUNE - FULL ADM KIT - PORTED IM - PORTED TB - PORTED CH - BLACK 3/8 ISOLATOR - TRIFECTA TUNED
DJ ATOMIX is offline   Reply With Quote
 
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
New! Retractable Front License Plate Frame/Holder! Hide your front license plate! RPI Designs Exterior Parts & Accessories 74 07-31-2020 08:29 AM
MOTORIZED FRONT LICENSE PLATE Matrix 5th Gen Camaro SS LS LT General Discussions 11 08-22-2009 06:10 AM
Hide away front license plate ? Travo Cosmetics and Lighting Modification Discussions 5 07-30-2009 02:27 PM
Looking for pic of front license plate bracket Top Flight Reproductions Camaro Photos | Spyshots | Video | Media Gallery 11 07-28-2009 12:04 AM


All times are GMT -5. The time now is 07:35 AM.


Powered by vBulletin® Version 3.8.9 Beta 4
Copyright ©2000 - 2026, vBulletin Solutions, Inc.