Passenger Rear Spring Problem - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

nikos30 · 12-02-2015, 04:20 PM

Installed by yours truly...

Why does this happen? I can install it in the right spot, but it comes out when I go over a bump at highway speeds.

It is only this spring out of the 4....Did I tighten it too tight?

The image is upside down....The top comes out of it's place.

STINGER BEE · 12-02-2015, 05:21 PM

That's weird the bottom is seated ok and up against is' t stop but the ? ,you sure it's tight enough instead of to much for it to pop like that.

Quote:

Originally Posted by nikos30

Installed by yours truly...

Why does this happen? I can install it in the right spot, but it comes out when I go over a bump at highway speeds.

It is only this spring out of the 4....Did I tighten it too tight?

The image is upside down....The top comes out of it's place.

nikos30 · 12-03-2015, 08:14 PM

Quote:

Originally Posted by STINGER BEE

That's weird the bottom is seated ok and up against is' t stop but the ? ,you sure it's tight enough instead of to much for it to pop like that.

I tightened it as hard as I could and i'm strong. I was thinking that I over tightened it...I have no idea though

12-02-2015, 04:20 PM	#1
nikos30 HT5 EastSide Drives: 2010 Camaro 2LT Join Date: Aug 2010 Location: NJ/PA Posts: 1,594 View My Garage	Passenger Rear Spring Problem Installed by yours truly... Why does this happen? I can install it in the right spot, but it comes out when I go over a bump at highway speeds. It is only this spring out of the 4....Did I tighten it too tight? The image is upside down....The top comes out of it's place. Attached Images __________________