Quad Gauge Pack retrofitted into 2nd Gen Ideas - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

MudDog · 01-22-2021, 07:03 PM

Hey,

I sourced a complete 2012 SS interior and installed it into my 71.

Naturally , and as expected, the gauge pack is either gonna have to be setup with a Computer controlled package , i.e. eng/trans , which Im not running OR ,

My thought is to take the correct PCM, mount it, connect up the correct 3 sensors, and take a 2012 harness segment and run the appropriate cabling, pwr/gnd,

Looking at the wiring diagram, its difficult to tell if there are dependencies from other connections to make this work.

Any input would be appreciated, wether its your nuts , or just cant be done , or do it this way , TIA

01-22-2021, 07:03 PM	#1
MudDog Drives: Camaro Join Date: Jan 2021 Location: Mobile Posts: 2	Quad Gauge Pack retrofitted into 2nd Gen Ideas Hey, I sourced a complete 2012 SS interior and installed it into my 71. Naturally , and as expected, the gauge pack is either gonna have to be setup with a Computer controlled package , i.e. eng/trans , which Im not running OR , My thought is to take the correct PCM, mount it, connect up the correct 3 sensors, and take a 2012 harness segment and run the appropriate cabling, pwr/gnd, Looking at the wiring diagram, its difficult to tell if there are dependencies from other connections to make this work. Any input would be appreciated, wether its your nuts , or just cant be done , or do it this way , TIA