Mighty Mouse Wild - Routed Correctly?

[dma05]

I just recently finished my Heartbeat supercharger install and added a Mighty Mouse Wild catch can as well. I wanted to make sure I routed it correctly.



I have the dirty side going from the oil breather and the clean side going into the inlet of the Supercharger.



The valley cover is plugged and so is the passenger side valve cover barb.



Also, I have the driver side valve cover barb going to the inlet of the air intake just after the air filter.


Thanks for any input.

[dreksnot]

That looks good.

What do you use the car for? Any autocross or road course?

[dma05]

I just use it for pleasure This is my project car. I do all the installs myself (first time doing most installs). I just like knowing I have the power when needed. I'm far from a race driver and I don't pretend to be one. I just like having a car that sounds awesome and can GO!

[URVINA42]

How did you do the coil relocation?

[dma05]

Originally Posted by URVINA42

How did you do the coil relocation?

I bought the coil relocation kit from CBM along with the 24" Harness Extension. I mounted them to the frame, which can be tricky. Definitely not easy to change the coils if needed, but doable.


I had to custom cut the MSD wires it came with. That took some time to learn, but was easy after 1 was done. Use lots of lube to get the boots on the wires!


Allen

[bayarea408]

i am plumbed up the same way on a L99 with my can since installation.

[dma05]

Would you guys recommend another catch can between the hose that is routed from the driver side valve cover to the intake pipe? Wouldn’t that pull oil into the intake and dirty up the throttle body and supercharger if bo catch can is in place?

Thanks!

[hammdo]

I did that - run 2 catch cans:





-Don

[dreksnot]

Originally Posted by dma05

Would you guys recommend another catch can between the hose that is routed from the driver side valve cover to the intake pipe? Wouldn’t that pull oil into the intake and dirty up the throttle body and supercharger if bo catch can is in place?

Thanks!

I run a smaller catch can off the rear of my driver's side valve cover. Not pulling any vacuum in it from anywhere though - just a vent hose from the valve cover to the can (for extra venting). I don't recall it capturing any oil.

[RupertPupkin]

eBay catch can, and put steel wool to catch oil vapors (just in case).

Hammdo—- that’s a mishimoto can right?

[dreksnot]

Hammdo

Does that top conversion fitting give you any benefit road coursing or autocross? Doesn't it just vent/drain to a larger reservoir but still capture a lot of oil. I filled my can up road coursing and autocross before spitting oil around the engine compartment and out the exhaust. I either have to weld a new fitting mid-section on my valve cover or empty the catch often when doing that kind of racing (I don't have the top conversion).