08-27-2012, 04:52 PM | #71 |
Drives: LS3S/C Join Date: Aug 2008
Location: CALI
Posts: 1,344
|
other than preventing heat soak how much hp gains will this set up give you. i have a whipple and the zl1 front fascia will the chiller fit my car
__________________
MODS whipple 2.9L s/c, ADM race scoop, 600 rwhp 550 wrtq, .
|
08-27-2012, 05:52 PM | #72 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
I gained zero HP without a tuning change, but you can add some timing if you want, mine was on the edge as it was. On the dyno I saw a 25rwhp retained with the chiller in other words after pass with it off I dropped 25rwhp and after that it continued to go down. With the chiller on it never lost a single HP! That in itself is a "GAIN" because your car will always be "HOT" at running tempature. So a 25-30 HP gain is reasonable at operating temps.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-27-2012, 06:03 PM | #73 | |
Drives: LS3S/C Join Date: Aug 2008
Location: CALI
Posts: 1,344
|
Quote:
__________________
MODS whipple 2.9L s/c, ADM race scoop, 600 rwhp 550 wrtq, .
|
|
08-27-2012, 06:07 PM | #74 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
This what I like the most about it, its makes me feel safer laying into out on the street when no race fuel is in the car and if I get bad gas its not nearly as likely to knock with 30* cooler IATs.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-27-2012, 06:22 PM | #75 |
Drives: LS3S/C Join Date: Aug 2008
Location: CALI
Posts: 1,344
|
i hear you man I'm runinng the stock block and would like to do so for many years but i know some day shit is going to happen, guess i'm trying to buy some time and keep on the safe side. so anybody does this installs in CALI i would like to get my chiller on before the winter
__________________
MODS whipple 2.9L s/c, ADM race scoop, 600 rwhp 550 wrtq, .
|
08-27-2012, 06:36 PM | #76 |
Do you even lift, bro?
|
Who's the closest installer to Ft Lee, VA? :P 1LE on order and putting on an SLP TVS2300 ASAP with CAI/LT headers and HF cats on the dual mode exhaust. From what I'm reading I can tune the car before this is added? Would it be easier to install at the same time as the TVS & headers etc? Likely going to have SLP install the TVS up in New Jersey where they are at. Thoughts? Thanks
__________________
My 1LE (645WHP/597WTQ) build/journal Thread:
1st ever 1LE COTW http://www.camaro5.com/forums/showthread.php?t=255461 |
08-27-2012, 07:24 PM | #77 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
Be easier all at once but it can be later.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-27-2012, 07:28 PM | #78 |
Do you even lift, bro?
|
Maybe I should check with SLP and see if they know how to install it. I suspect I have to have one of their approved installers though to maintain whatever warranty they might offer. I know you have it so I'd appreciate any intel you can offer. PM if necessary. Thanks!
__________________
My 1LE (645WHP/597WTQ) build/journal Thread:
1st ever 1LE COTW http://www.camaro5.com/forums/showthread.php?t=255461 |
08-27-2012, 07:37 PM | #79 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
It is not real hard, need someone who can evac the A/C system and charge it again, but they prolly have to do that anyway, and other than some wiring and pulling the front facia off nothing really more to it after than just splice the water hoses and a couple relay mounts and vaccume lines. SLP should be able to do it, not sure if they will or not, just have to ask.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-27-2012, 07:41 PM | #80 |
Do you even lift, bro?
|
Happen to know the closest installer to me in VA? I know they are in FL and I saw something about someone in NC but not sure they were installing yet. Think it's worth the $800 plus install costs(guessing $100ish)
__________________
My 1LE (645WHP/597WTQ) build/journal Thread:
1st ever 1LE COTW http://www.camaro5.com/forums/showthread.php?t=255461 |
08-27-2012, 07:55 PM | #81 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
I would say its not $100 to install, I would guess 4+ hours so depending on shop rate.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-27-2012, 07:56 PM | #82 |
Drives: 08' F250 Diesel & 10' Camaro 2SS Join Date: Nov 2010
Location: Gainesville,Fl
Posts: 1,362
|
Not sure on closest installer. PM Dave (Trek GTO) and ask or he will prolly see this thread and answer.
__________________
08' F250 CCSB 6.4L Diesel White & Black, Blacked out, 580RWHP @ 55psi 13.21 @ 101mph
10' Camaro 2SS LS3 M6 White & Black, Blacked out, 684 RWHP & 633 FT.LBS @ 10psi 10.82@130mph TVS2300 ,Hendrix Street Slayer Twin Carbon Clutch, Dana 60 3.73, DSS 1400HP Axles,JRe cam & LaMotta Performance tuned,LPE Fuel, AI Super Chiller,MT ET Streets |
08-28-2012, 05:01 AM | #83 | |
Drives: 05 GTO / JETTA TDI Join Date: Jan 2012
Location: St Pete Fl
Posts: 630
|
Quote:
We recommend 5 hrs installation but some first timers have taken longer. |
|
08-28-2012, 05:13 AM | #84 | |
Drives: 05 GTO / JETTA TDI Join Date: Jan 2012
Location: St Pete Fl
Posts: 630
|
Quote:
Are you going to The Late Model Muscle Car event at Bradenton October? |
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Whiteside Customs Super Street 1 Package - Install Thread | Whiteside Customs | Suspension / Brakes / Chassis | 5 | 12-12-2011 08:40 PM |
Drag Racing..."Real Street Cars" | Steve Dallas | Dragstrip and Launch Techniques Discussion | 40 | 09-04-2011 11:02 AM |
Portable Dynamometer added to Houston Super Chevy Show Midway, Sept. 11-12 | Houston Raceway | USA - Texas | 6 | 09-01-2010 11:26 PM |
LG g6x3 or Super Charger Cam!!! Your Thoughts | Mr. Brownstone | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 30 | 01-24-2010 01:45 PM |
Shelby Super Snake | KILLER74Z28 | General Automotive + Other Cars Discussion | 18 | 07-23-2007 07:12 PM |