![]() |
|
|
#15 | |
|
502 RWHP N/A
|
Quote:
__________________
factory motor factory trans, Gpi ss4 cam stock heads ported and milled, full exhaust, circle d 5c 4000 triple disk, 3:91 rear end with posi mod, cai, bmr derlin rear diff bushins, bmr derlin cradle bushins, bmr trailing arms, toe rods with bushings, and bmr anti extreme sway bar. Weld rt-s 17x5 fronts and 17X10 rears on mickey thompson et street r's
|
|
|
|
|
|
|
#16 |
![]() ![]() ![]() ![]() Drives: 11' SGM 2SS/13' GT/08' F-150 4x4 Join Date: Mar 2011
Location: League City, Tx
Posts: 1,264
|
AFM??
__________________
|
|
|
|
|
|
#17 |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
No AFM isnt the issue... unless its not working correctly. I know how it feels.. had it on my G8 too. I have an appt on Friday to get it looked at. Maybe it is the gas here. But at 15 and 55 it pulls hard and jumps up to 4500 rpm. At 56-69 mph its hitting 3800 rpm and pulling slow. At 20, its not dropping into 1st... its hitting about 3200 rpm when kicked into passing gear. At 45.. its right around 4000 rpm. 15 and 55 are the only speeds where it will sit you back and go and I believe this is caused by the car not downshifting into the correct gear. It MAY have something to do with the fuel... but I did the fuse pull before and noticed an instant improvement. Before the fuse pull it was falling on its face no matter what gear it downshifted to.
|
|
|
|
|
|
#18 | |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
Quote:
I used the Superchips Cortex on the G8 I had and it was great. Where is a good place to get one for the SS? This might be plan B |
|
|
|
|
|
|
#19 |
![]() Drives: aqua blue ls and inferno orange ss Join Date: Feb 2010
Location: Florida
Posts: 216
|
|
|
|
|
|
|
#20 |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
So does any one have any input as to what their car does? I've been testing this out a lot lately. On the way home from work I set the cruise at 25 mph, put the car in S for about a min, then I floored it. It jump to 2800 rpm. Thats it. At 55 mph, it hit 4800 ish and pulled hard. So what rpm are you guys hitting at what speeds when you floor it? I'm really interested to hear what you guys get from a 60 roll or 20 roll.
|
|
|
|
|
|
#21 |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
no one has any input as to what their car does?
|
|
|
|
|
|
#22 |
![]() Drives: 2009 Pontiac G8 GT Join Date: Sep 2009
Location: Victoria, TX
Posts: 52
|
When you're going 25mph, you are above what the stock TCM will allow for a downshift to 1st gear. You only get a downshift to 2nd gear and it feels really lazy I'm sure. If you have your TCM tuned, you can get fast downshifts to 1st gear above 30mph. Just need a tune.
__________________
2013 Corvette Grand Sport A6 Forged 416, Greg Good ported TFS 255 LS3 heads, ECS NOVI 1500 blower, 222/242 .629/.604 121LSA EPS cam, ARH 1 7/8" headers, NPP exhaust, 747rwhp/709rwtq on 93 octane, no meth, w/stock street manners. 2014 GMC Yukon XL Denali, Air Raid MIT, tuned. 2009.5 Pontiac G8 GT 6.0L, A6, AFR 230v2 heads. 506rwhp/442rwtq. 11.413 @ 121.29mph 1/4 mile, 168.7mph Texas Mile 2000 Pewter Ram Air Trans Am M6 heads/cam 508 rwhp/445 rwtq SAE, 183.092 Texas Mile LS1,LS2,LS3,LS7 Custom Camshaft Specialist |
|
|
|
|
|
#23 | |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
Quote:
|
|
|
|
|
|
|
#24 | |
![]() Drives: 2009 Pontiac G8 GT Join Date: Sep 2009
Location: Victoria, TX
Posts: 52
|
Quote:
__________________
2013 Corvette Grand Sport A6 Forged 416, Greg Good ported TFS 255 LS3 heads, ECS NOVI 1500 blower, 222/242 .629/.604 121LSA EPS cam, ARH 1 7/8" headers, NPP exhaust, 747rwhp/709rwtq on 93 octane, no meth, w/stock street manners. 2014 GMC Yukon XL Denali, Air Raid MIT, tuned. 2009.5 Pontiac G8 GT 6.0L, A6, AFR 230v2 heads. 506rwhp/442rwtq. 11.413 @ 121.29mph 1/4 mile, 168.7mph Texas Mile 2000 Pewter Ram Air Trans Am M6 heads/cam 508 rwhp/445 rwtq SAE, 183.092 Texas Mile LS1,LS2,LS3,LS7 Custom Camshaft Specialist |
|
|
|
|
|
|
#25 |
![]() Drives: 2011 Inferno Orange 2SS/RS A6 Join Date: Jun 2011
Location: Warner Robins, GA
Posts: 141
|
So where do I get one at? When I had a G8 I just used superchips. I'm asking because youre not TOO far away and I'm moving so I will bill driving through Texas
|
|
|
|
|
|
|
|
![]() |
| Thread Tools | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear End Gears 101 | danhr | V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) | 92 | 06-02-2021 05:17 AM |
| the notchy 3rd gear issue | KKJ | V8 and V6 Transmissions / Driveline (6L80 / 6L50 / TR6060 / AY6) | 23 | 05-03-2011 04:26 PM |
| L99 sounds like it is in to high of gear, then BAM it take off like a bat out of HEll | speed racer | Camaro V8 LS3 / L99 Engine, Exhaust, and Bolt-Ons | 9 | 03-12-2010 02:55 AM |
| Clarification Please! L99 and 1st gear | Ace | 5th Gen Camaro SS LS LT General Discussions | 6 | 05-22-2009 04:34 AM |
| Do you think it was right that the mustang got to use the trackpack in the comparison | perfxn | Chevy Camaro vs... | 91 | 03-30-2009 10:44 PM |