10-23-2009, 07:49 PM | #1 |
Drives: 2010 Black SS Join Date: Sep 2009
Location: San Francisco, CA
Posts: 352
|
Installing new Shift Knob question.
Just got my Hennessey shift knob, got excited ran down to the car, pulled the old one off and started trying to put it on. The big problem i'm having is getting the zip-tie things that holds the cloth to the knob to well, get in there and work. Is there any way to get it in there and tighten it around the knob? or is it just a total pain in the ass.
Any help would be appreciated. |
10-23-2009, 08:25 PM | #2 |
Drives: 2008 Z06 Join Date: Apr 2009
Location: Oviedo, Florida
Posts: 891
|
i dont know how the henneseeyt is put on, but if you look at the hurst install that may help you tie the boot....
you can take off the boot and slide if from the top to zip tie it. hope this helps
__________________
|
10-23-2009, 09:41 PM | #3 |
Drives: 2010 Black SS Join Date: Sep 2009
Location: San Francisco, CA
Posts: 352
|
figured it out thanks to you! Thanks a ton.
|
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
question about the stick... | NightmareSS | 5th Gen Camaro SS LS LT General Discussions | 14 | 09-18-2009 12:48 PM |
Question About Camaro | Copre | 5th Gen Camaro SS LS LT General Discussions | 7 | 09-06-2009 10:56 PM |
Question about steering wheel and shift knob | jeansonne627 | Camaro V6 LLT Engine, Exhaust, and Bolt-Ons | 15 | 08-27-2009 03:45 PM |
Shifter knob question | CamaroorNothin | 4th Generation Camaros | 2 | 04-18-2008 09:51 PM |
No-Lift Shift | AirGoya | 5th Gen Camaro SS LS LT General Discussions | 29 | 03-09-2008 11:08 AM |