engine won´t start when hot - problem solved - Page 8 - Camaro5 Chevy Camaro Forum / Camaro ZL1, SS and V6 Forums

camguynj · 11-05-2021, 06:48 PM

Quote:

Originally Posted by caper

https://www.autozone.com/batteries-s...able/95947_0_0

looked like that, about 18" long...looked A LOT like the one sold for much more at the camaro site...bolted up fine to both bolts and looped over the exhaust.

Did you add it to the trunk ground or engine block?

caper · 11-05-2021, 07:29 PM

Quote:

Originally Posted by camguynj

Did you add it to the trunk ground or engine block?

added it to the trans mount bolt and then to the passenger underside. theres a bolt there.

camguynj · 11-06-2021, 07:30 AM

Quote:

Originally Posted by caper

added it to the trans mount bolt and then to the passenger underside. theres a bolt there.

May want to add an extra cable to the trunk ground too. Can’t hurt. That's where I added mine as I was having just a little hot start hesitation and it took care of it. The trunk ground is a screw not a bolt and it isn't very robust and its bottom is exposed to the road surface. Mine had some rust so when I added the extra ground cable I cleaned the screw and applied some dielectric grease. If you think about it that one connection is the source for all the other grounds.

1JEWLDSSRS · 11-06-2021, 09:26 AM

Quote:

Originally Posted by caper

https://www.autozone.com/batteries-s...able/95947_0_0

looked like that, about 18" long...looked A LOT like the one sold for much more at the camaro site...bolted up fine to both bolts and looped over the exhaust.

Thanks sir. Guess I should have asked that question better, I meant a pic of "where" you installed the cable. Sorry. lol. I have a cable just like that one sitting on my work bench.

caper · 11-06-2021, 04:04 PM

Quote:

Originally Posted by 1JEWLDSSRS

Thanks sir. Guess I should have asked that question better, I meant a pic of "where" you installed the cable. Sorry. lol. I have a cable just like that one sitting on my work bench.

watch the vid...exactly what i did.

https://www.gen5diy.com/products/10-...f836a8f8&_ss=r

Joe.G · 11-06-2021, 09:57 PM

Caper was teh Body Bolt there or did you need to add it? If you added the bolt do you remember what thread? Also How long of a cable do I need to get? Thanks

caper · 11-06-2021, 10:18 PM

Quote:

Originally Posted by Joe.G

Caper was teh Body Bolt there or did you need to add it? If you added the bolt do you remember what thread? Also How long of a cable do I need to get? Thanks

it was already there. the cable i picked up was about 18" long or so - looked A LOT like the one in the link above, but cost much less.

Joe.G · 11-07-2021, 08:07 AM

Yeah, That line is way over priced, I can make my own for under $10. I'll Make one up and add it when i do my headers. This is better than adding to the trunk/Battery?

camguynj · 11-07-2021, 08:24 AM

Quote:

Originally Posted by Joe.G

Yeah, That line is way over priced, I can make my own for under $10. I'll Make one up and add it when i do my headers. This is better than adding to the trunk/Battery?

Either will provide extra electrons/power to the starter. Adding to the trunk is ezer
https://m.youtube.com/watch?v=pbSCICsau0M

1JEWLDSSRS · 11-07-2021, 10:45 AM

Quote:

Originally Posted by caper

watch the vid...exactly what i did.

https://www.gen5diy.com/products/10-...f836a8f8&_ss=r

Thanks caper, much appreciated...

1JEWLDSSRS · 11-07-2021, 10:49 AM

Quote:

Originally Posted by camguynj

Either will provide extra electrons/power to the starter. Adding to the trunk is ezer
https://m.youtube.com/watch?v=pbSCICsau0M

Hey, also thanks camguynj for this as well...

camguynj · 11-07-2021, 01:35 PM

Quote:

Originally Posted by 1JEWLDSSRS

Hey, also thanks camguynj for this as well...

Post a followup after you attach it

1JEWLDSSRS · 11-08-2021, 09:34 AM

Quote:

Originally Posted by camguynj

Post a followup after you attach it

Yes sir, will do. Thanks...

Joe.G · 11-08-2021, 09:16 PM

I grabbed 2 19 Inch cables from Auto ZOne today, one was 4 Ga and the other was 6 Ga, Not sure which I'll use yet, they cost me $14.00 for both.

11-06-2021, 09:57 PM	#104
Joe.G Drives: 2014 2SS/RS 6SP Ashen Grey Join Date: Aug 2021 Location: NY Posts: 1,655	Caper was teh Body Bolt there or did you need to add it? If you added the bolt do you remember what thread? Also How long of a cable do I need to get? Thanks __________________ GM 3.91/TrueTrac OEM ZL1 Rims, 6 Piston Brakes & Side Skirts.ACST4 Splitter/Deflectors NPP M2W,GM Short Throw,GPI Ported Rod Mod,BO White PTB,CAI/JRE Scoop, GC Aluminum DS,Stainless Works Ceramic LTH/HiFlo Cats, Hotckis 1" Springs & Chassis Max Brace BMR Adjustable Swaybars,Trailing Arms, Adjustable Toe Rod, LCA & Z28 UCA Bushings Hendrix Solid Cradle Bushings Pedders Radius Rod Inserts Strut tower brace, Moroso Catch Can,SCT X4 Dynosteve,Remote Clutch reservoir,Hero Smoked Tail and 3rd Brake Light, Diode Dynamic SL1 Fog Lights AeroForce Dual gauge/Autometer pillar mount.

11-07-2021, 08:07 AM	#106
Joe.G Drives: 2014 2SS/RS 6SP Ashen Grey Join Date: Aug 2021 Location: NY Posts: 1,655	Yeah, That line is way over priced, I can make my own for under $10. I'll Make one up and add it when i do my headers. This is better than adding to the trunk/Battery? __________________ GM 3.91/TrueTrac OEM ZL1 Rims, 6 Piston Brakes & Side Skirts.ACST4 Splitter/Deflectors NPP M2W,GM Short Throw,GPI Ported Rod Mod,BO White PTB,CAI/JRE Scoop, GC Aluminum DS,Stainless Works Ceramic LTH/HiFlo Cats, Hotckis 1" Springs & Chassis Max Brace BMR Adjustable Swaybars,Trailing Arms, Adjustable Toe Rod, LCA & Z28 UCA Bushings Hendrix Solid Cradle Bushings Pedders Radius Rod Inserts Strut tower brace, Moroso Catch Can,SCT X4 Dynosteve,Remote Clutch reservoir,Hero Smoked Tail and 3rd Brake Light, Diode Dynamic SL1 Fog Lights AeroForce Dual gauge/Autometer pillar mount.

11-08-2021, 09:16 PM	#112
Joe.G Drives: 2014 2SS/RS 6SP Ashen Grey Join Date: Aug 2021 Location: NY Posts: 1,655	I grabbed 2 19 Inch cables from Auto ZOne today, one was 4 Ga and the other was 6 Ga, Not sure which I'll use yet, they cost me $14.00 for both. __________________ GM 3.91/TrueTrac OEM ZL1 Rims, 6 Piston Brakes & Side Skirts.ACST4 Splitter/Deflectors NPP M2W,GM Short Throw,GPI Ported Rod Mod,BO White PTB,CAI/JRE Scoop, GC Aluminum DS,Stainless Works Ceramic LTH/HiFlo Cats, Hotckis 1" Springs & Chassis Max Brace BMR Adjustable Swaybars,Trailing Arms, Adjustable Toe Rod, LCA & Z28 UCA Bushings Hendrix Solid Cradle Bushings Pedders Radius Rod Inserts Strut tower brace, Moroso Catch Can,SCT X4 Dynosteve,Remote Clutch reservoir,Hero Smoked Tail and 3rd Brake Light, Diode Dynamic SL1 Fog Lights AeroForce Dual gauge/Autometer pillar mount.